HAND HELD DIGITAL TRANSMITTER
CANSEC T306 / T206 TRANSMITTERS
RF MODULE &
SECURIT
1 Description
PRODUCTS USER’S GUIDE
The T306 Series Transmitter is ideal for the opening, closing the garage door and control the winch of
hoist machine. The Transmitter is available in hand-held and transmits a unique code each time the switch
is closed to provide a secure control. The transmitter is powered by a 12-volt battery and a blue indicator
light when the transmitter is activated.
T306 T206 T306 T206
2 Specifications
DESCRIPTION SPECIFICATION
FREQUENCY 340MHz
EMITTED RADIO POWER <8dBm
POWER CONSUMPTION Max 12mA
OPERATING TEMPERATURE -10˚C~+55˚C
DIMENSIONS 75mmx38mmx13mm
CERTIFICATION FCC
3 Battery Replacement
1.Remove screw from back of transmitter.
2.Separate housing and install a fresh 12-Volt/23A ALKALINE battery making sure to observe properly
polarity.
3.Reassemble housing and replace screw.
4 FCC Compliance
1
The Digital Transmitter complies with part 15 of the FCC rules. Operation is subject to the following
two condition:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful inference in a residential installation.This equipment generates, use and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on , the user is encouraged to try
to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
--The user’s manual or instruction manual for an intentional or unintentional radiator shall caution the
user that change or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device is tested and found compliance with the FCC Part 15.231 for the periodic operation.
In order to maintain the compliance, and under the definition of periodic operation, NO continuous operation
is allowed. User MUST take caution of the operation NOT MORE THAN 5 SECOND, otherwise could void the
user's authority to operate this product and must take responsible for this violatio n.
changes or modifications not expressly approved by Beijing Jia An Electronic Technology Co,.Ltd. fo
compliance could void the user's authority to operate the equipment.
5 Company Contact
Beijing Jia An Electronic Technology Co,.Ltd.
Add: No.19 Gu Cheng west street, Shi Jing Shan District, Beijing 100043, CHINA
TEL: +86-10-6888 9971 / 6888 9972 / 6888 9973
FAX: +86-10-6888 9905