BeiHai Innotech Technology CKWL0507 User Manual

Front
70 mm
Instruction Manual
Wireless Charging Pad
Model: CKWL0507
Please read the manual carefully before use.
Attention
For the fastest and safest charge, please use USB charger or power bank with an output 5V 2A.
Don’t expose to liquids.
Don’t disassemble. Avoid dropping.
Avoid extreme temperatures.
FCC Statement
1.This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: this device may not cause harmful interference. this device must accept any interference received, including interference that may cause undesired operation.
Using Your Wireless Charging Pad
1. Plug it into a USB charger or power bank (as below Pic).
2. Place your phone or tablet on the center of your wireless charging pad.
Back
2. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
3. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
a. Ready to charge: Light is off. b. Charging: Solid blue. c. Error: Blinking blue.
Accessories list
Wireless Charging Pad x 1 Micro USB Cable x 1
Instruction Manual x 1
Specifications
Input: 5V 2A
Output: 5W Max
Size: 120 x 100 x 13.5mm
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
Made in China
70 mm
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving an  tenna.
Increase the separation between the equipment and receiver. 
Connect the equipment into an outlet on a circuit different from that to which the  
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. 
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Loading...