Behavior Tech Computer KB6309URF3, RX6309URF3, MS6309URF3 User Manual

BTC , EMPREX

Wireless Keybaord +Mouse + USB dongle

6309URF III Quick Installation Guide

Hardware Installation

1. Plug the dongle receiver connector into your available USB port on PC.

2. Make sure the batteries of the keyboard and mouse are installed correctly. Please follow the polarity signs in the battery compartment.

3. Please make sure the power switch on the back of the mouse is switched to “on” before using the mouse. When not in use, please turn the power switch to “off” for power saving.

ID Pairing Procedure

After you plug the receiver USB connector into your PC USB port, please hold the keyboard and mouse close to the receiver within 1M and press any key to pair ID. If it can’t work, please follow the

steps below to process the ID pairing procedure. The ID-recognition function helps to protect against interference from other RF products in the same environment.

change ID when other RF products affect your keyboard kit.

 ID pairing procedures:

1. Press and hold the ID pairing/connect button on the top of the dongle receiver at least 5 seconds until the receiver LED flashes. The receiver LED will flash 60 seconds to wait for keyboard and mouse pairing information. (If you release the button within 5 seconds, the ID doesn’t make any changes.)

2. Hold the keyboard and mouse close to the dongle receiver within 1M.

3. Press and hold the keyboard ID pairing/connect button on the bottom of the keyboard at least 5 seconds until the keyboard LED, which is on the upper right of the keyboard, flashes once. (If you release the button within 5 seconds, the ID pairing will fail.)

4. Press and hold the mouse ID pairing/connect button on the bottom of the mouse at least 5 seconds until the battery low indicator flashes once. (If you release the button within 5 seconds, the ID pairing will fail.)

Note:

- Each procedure should be completed within 60 seconds.

- Make sure your PC is on and running when doing the pairing

procedure.

- You don’t have to pair ID again after changing batteries. If it can’t work, please follow the steps above to pair ID.

- Both the keyboard and mouse can operate freely up to a radius of about 10m from the receiver.

- Keyboard battery life is up to 13 months and mou se battery life is up

to 8 months. It depends on the intensity of usage.

Remember to follow the steps below to

Front view of Back view of USB connector USB connector

ID pairing/connect button on the top of the dongle receiver (With a LED indicato under the IDpairing/connect button)

ID Pairing /connect button on the bottom of the mouse

ID pairing /connect button on the bottom of the ke

Pairing Button

Power Switch

board

System Requirements

 Available USB port  CD-ROM drive (for CD and Video operation)  Standard sound card (for CD and Video operation)  Microsoft® Internet Explorer 5.0 or later version (for the Internet keys)

 Microsoft® Windows® ME, Windows® 2000, Windows® XP or Windows Vista® operating system

English

BTC , EMPREX

Wireless Keybaord +Mouse + USB dongle

Important Usage Information

English

 Battery:

1. We recommend using alkaline batteries for a longer battery life.

2. Always change batteries when battery low alarm appears, otherwise the mouse or keyboard will shut down once the battery

voltage is too low.

3. Don't mix different types of batteries or new and old batteries together. Always replace old batteries with new and same type

batteries.

4. Remove batteries after long periods of non-use. Battery leakage or corrosion may damage the device quality and cause

danger.

5. Keyboard battery life is up to 13 months and mouse battery life is up to 8 months. It depends on the intensity of usage

 Mouse usage:

1. This laser mouse can work on most surfaces, including polished or wood-grain surfaces.

2. While functioning, this mouse emits invisible laser light that may be hazardous to eyes. Avoid looking directly into the emitter

hole on the bottom of the mouse.

 Battery Low Alarm:

1. Mouse battery low alarm:

- When the mouse battery is low, the RED LED indicator under mouse scroll wheel will blink when the mouse is moved. Please change batteries immediately when the RED LED indicator lights up to ensure the good use of this mouse. After you change the batteries, the RED LED indicator will disappear.

2. Keyboard battery low alarm:

- When the keyboard battery is low, the RED LED indicator, which is on the upper right of the keyboard, will blink when you press keyboard buttons. Please change batteries immediately when the RED LED indicator lights up to ensure the good use of this keyboard. After you change the batteries, the RED LED indicator will disappear.



Laser Safety Information

This product complies with International Standards EN 60825-1/A2: 2001, Class 1 Laser Product, and also complies with FDA standards Title 21 CFR 1040.10 and 1040.11, except for deviations pursuant to Laser Notice No.50, dated June 24, 2007.

+ 3 hidden pages