Behavior Tech Computer KB9129URF3 User Manual

9129URFⅢ WWiirreelleessss KKeeyybbooaarrdd UUsseerr’’ss GGuuiiddee

USB Plug

Hardware Installation

Step 1: Make sure your PC is switched off.

Step 2: Connect the receiver to your PC by plugging in the receiver’s black

connector into the USB port of your PC .

Step 3: Take the keyboard and make sure the batteries on the back are installed

correctly. (Follow the polarity signs in the battery compartment.)

Bottom View of Keyboard

Remarks:

1. The keyboard uses 4 pcs. standard UM-3 (AA) 1.5V alkaline batteries.

2. Battery life is approximately 3-4 months, depending on the intensity of usage.

3. Make sure the receiver is placed in a location where is relatively free of strong
electromagnetic or transmission sources in order to ensure optimal reception of the
keyboard signal.

ID Setting

This wireless keyboard kits have 255 sets ID in each unit. This extra ID-recognition
function helps to protect against interference from other RF keyboards in the same
environment.

Ø The word CONNECT labels the ID button on each unit.

Ø The LED under ID button of receiver shows connecting condition.

Step 1: Press the ID button on the side of the receiver once.

Step 2: Press the ID button on the bottom of the keyboard once.

ID Button of Keyboard

Remarks:

1. You must follow the procedure above to set the ID of receiver and keyboard.

Once the receiver ID button is pressed you have 35 seconds to complete the
entire process, or you will need to begin again.

2. Once the keyboard and receiver are plugged in, the yellow receiver light will flash.

Once the ID is set, it will remain steadily lit.

3. When changing the batteries of keyboard, there is no need to reset all the ID’s.

Simply reset one of them.

4. When keyboard batteries are low, a battery low icon will show on the system

tray.

5. When mouse batteries are low, a battery low icon will show on the system

tray.