Beglec UT-16 V 1.1, MR-SU9 V 1.1, UF-16 V 1.1 User Manual
MR-SU9
UHF Diversity Receiver
UF-16
Hand Microphone
UT-16
Belt Pack Transmitter
Operation Manual
Mode d'emploi
0681 !
§ This equipment fullfills the legal requirements in Belgium, France, Germany, Austria, Netherlands and
Great Brittain.
§ Cet appareil remplit les conditions légales pour la vente enBelgique, France, Allemagne, Autriche, Hollande
et Angleterre.
§ Dit apparaat mag wettelijk bebruikt worden in België, Nederland, Frankrijk, Duitsland, Oostenrijk en GrootBrittanië.
§ Dieses Gerät erfüllt die landeüblichen Bestimmungen in Belgien, Frankreich, Deutschland, Niederlände
und England. Auch geprüft nach der schnistelle FSB-LD016!, Verwendbar in Österreich.
WWW.JBSYSTEMS.BE
Version: 1.1
Gebruiksaanwijzing
Bedienungsanleitung
The Power Source for DJ’s
EN
FR
NL
DU
ENGLISH
Operation manual
PRECAUTIONS
• Before connecting and operating the unit, check if the voltage
setting is conform to the voltage available in your area.
• Avoid extremely dirty or dusty environments.
• Avoid areas where there is extremely high humidity.
INSTRUCTIONS
Thank you for purchasing a PLL Synthesized Diversity Wireless
Microphone System!
The UHF high band wireless microphone and receiver are high
quality audio products.
The PLL synthesized diversity wireless microphone system operates
on UHF band frequency 863-865 MHz with 16 selectable channels.
Please read this instruction manual completely before operating the
system.
This manual covers the function and operation of the Wireless
Microphone system.
MR-SU9 + UT-16A + UF-16A
2
FEATURES
1. Operating on UHF band frequency 863-865 MHz with PLL
synthesized control.
2. 1/2 19" size case with power & RF indicators.
3. PLL (Phase Locked Loop) synthesized wireless microphone
system with 16 selectable frequencies makes it easy to
choose non-interference channels.
4. Excellent reception system ensures super high sensitivity.
5. SMT assembled PCB module ensures the quality and stability
for easy installation and quick replacement.
Especially convenient to after service.
6. RF input with RF-preamplifier to improve signal-noise and get
high sensitivity and wide dynamic range.
7. Low noise mixer circuitry helps to reduce the noise from interference to minimum.
8. 12 V-18 V DC Power Supply.
3
MR-SU9 + UT-16A + UF-16A
RECEIVER
SPECIFICATIONS
Carrier Frequency Range : UHF 863-865 MHz
Frequency Stability : ± 0.005 % with PLL syntesized
controlled
S/N Ratio : Over 105 dB at 60 dB/µ V
Image & Spurious Rejection : 80 dB minimum
Receiving Sensitivity : 8 dB/µ V, at 80 dB S/N ratio
Selectivity : More than 50 dB
Dynamic Range : More that 96 dB
Modulation Mode : FM
IF Frequency : 1st: 56 MHz, 2nd: 10.7 MHz
Service area : Over 50 Meters
AF Response : 40 Hz to 15 KHz (± 3 dB)
THD : Less than 0.5 % (at 1 KHz)
Audio Output : Unbalanced: max. 775 mV
(0dB=0.775V) at 5 Kohm Load
Power Supply : DC 12 - 18 V Adapter
MR-SU9 + UT-16A + UF-16A
4
Front Panel
Rear Panel
5
MR-SU9 + UT-16A + UF-16A
1 .......... Power Switch
2 .......... Channel Selector
3 .......... Power Indicator
4 .......... Diversity AB Indicator
5 .......... Volume Control
6 .......... Antenna B
7 .......... Balanced Output
8 .......... Unbalanced Output
9 .......... Squelch Adjustment
10 ........ DC Socket
11 ........ Antenna A
OPERATION
1. Connect the phone plug cable; one end to the jack of Audio
out, another end to the Mic mixing jack of Karaoke Amplifier,
audio mixer, etc...
2. Please set the same frequency which is not interfered in local
area for receiver and microphone.
3. The squelch level is adjustable by the squelch adjustment at
the back of the unit, adjust the output level to prevent from
the external noise. (Setting the squelch to high will reduce
the range of the system).
4. When the receiver is not used, remove the power supply.
MR-SU9 + UT-16A + UF-16A
6
CASE 1
CASE 2
CASE 3
7
MR-SU9 + UT-16A + UF-16A
MICROPHONE
FEATURES
1. High sensitivity cardioids capsule.
2. Special noise absorption parts inside the barrels,
which eliminate switch shock noise and handling noise.
3. Frequency with PLL synthesized control.
4. Easy-opening battery compartment for quick battery
replacement.
5. Low battery LED inidicator.
6. The Lavalier microphone is easy to clip on the belt and very
light. It can be used easily with headset mic with 3.5 mm plug.
OPERATION
1. Push to open the battery cover.
2. Insert 1.5V x 2 batteries into the battery holder according to
polarity (+) and (-) indication marked on the battery housing.
3. Fit battery cover back.
4. After setting the chosen frequency same as the receiver, push
the power switch to ‘ON’, the LED indicator will flash to indicate
the carrier frequency is sending out.
5. Push the power button OFF when the microphone isn’t used
and remove the battery in the microphone if not used for a
long time. This will prevent any damage that a defective
‘leaking’ battery may cause.
6. Switch the power ‘ON’, the LED indicator flashing means that
power supply is normal. If the LED indicator lights up it means
that the battery is in need of replacement.
If there’s no flashing, there is no battery or battery is not
properly inserted.
MR-SU9 + UT-16A + UF-16A
8
FEATURES
Carrier Frequency Range : UHF band 863-865
RF Power Output : 2 MW (max.)
Spurious Emission : More than 45 dB below carrier
frequency
Frequency Stability : Within ±0.005 % with PLL
synthesized control
AF Response : 40 Hz to 15 KHz (± 3 dB)
Maximum Deviation : ± 15 KHz within limiting compressor
S/N Ratio : 60 dB (A-weighted)
Microphone Capsule : Uni-directional dynamic microphone
Operating Voltage : DC 1.5V x 2 (UM-3 type)
Current consumption : About 65 mA (max.)
LED Indicator : Power On - Off and low battery
HANDHELD MICROPHONE
9
MR-SU9 + UT-16A + UF-16A
1. Screen Head
2. Low Battery Led Indicator
3. ON/OFF Switch
4. Mic Housing
5. Channel Selector
6. Battery Housing
7. Antenna
8. Battery Cover
TIE CLIP MICROPHONE
1. LED
2. ON/OFF Switch
3. Mic Unit
4. Tie Clip
5. Cable
6. Channel Selector
7. Gain Selector
8. Antenna
9. Battery Housing
MR-SU9 + UT-16A + UF-16A
10
NOTE
This system can be used legally in the following European
countries: Belgium, France, Germany, The Netherlands and the UK.
TROUBLE SHOOTING
Please take time to read this manual before asking after service
and check following points. If it contains unusual things please
contact your purchasing store. They will be happy to help you.
1. Before connecting and operating the unit, check that the
voltage setting is conform the voltage available in your area.
2. If the LED indicator lights on it means that the power supply
needs to be replaced. Please replace with new 9 V battery and
make sure the polarity (+)(-) of the battery is connected
properly.
3. Signal dropouts and noise may suddenly be encountered by
interruption from outside, too much distance between
microphone and receiver or low power of the battery.
In such case, adjust receiver antenna or replace battery.
4. Do not drop the microphone on a hard concrete floor,
nor strike the microphone head front with a fist or fingers,
nor blow/breath heavily into the microphone head front.
5. Take out the battery when not used for a long time. This will
prevent damage that a defective ‘leaking’ battery may cause.
11
MR-SU9 + UT-16A + UF-16A
FRANCAIS
Mode d’emploi
PRECAUTIONS
• Avant de racorder et d’utiliser l’appareil, vérifiez que la tension
affichée soit celle utilisée chez vous.
• Évitez une utilisation dans des environnements extrêmement
sales ou poussiéreux.
• Évitez une utilisation dans un environnement extrêmement
humide.
INSTRUCTIONS
Nous vous félicitons d’avoir acheté un Système de Microphone sans
Fil avec bouclage par quartz!
Le UHF haute bande de comprenant le microphone sans fil et son
recepteur sont de haute qualité sonore.
Le système de microphone sans fil travaille dans une plage de
fréquences UHF 863-865 MHz avec quartz de bouclage.
Nous vous remercions de bien vouloir lire complètement le présent
manuel avant d’utiliser le système.
Ce manuel recouvre les fonctions et fonctionnalités du système du
Microphone sans Fil.
MR-SU9 + UT-16A + UF-16A
12
PERFORMANCES
1. Fonctionne dans la bande UHF 863 - 865 MHz avec bouclage
par quartz.
2. Boitier 1/2 19" avec des témoins d'allumage et de signal RF
3. Micro émetteur avec bouclage par quartz. Le micro est équipé
avec un sélecteur de 16 fréquences differentes. Ceci vous
permet de facilement trouver une fréquence non-interpheré.
4. Très bonne réception et sensibilité exceptionelle du système.
5. Le circuit imprimé en CMS assure une qualité et une stabilité
à long terme ainsi qu’une installation et un remplacement rapide. Il est extrèmement commode pour l’entretien.
6. Circuit RF avec préampli RF pour améliorer la reception et
pour augmenter la sensibilité.
7. Des composants de haute qualité dans la partie mélangeur
aident à réduire le bruit d’interférence.
8. Alimentation 12 V - 18 V DC
13
MR-SU9 + UT-16A + UF-16A
Loading...