Beghelli TEMPESTA PLUS HT Instructions Manual

TEMPESTA PLUS (TA PLUS-LED)

TM

INSTRUCTIONS

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed including the following:

CAUTION! ALWAYS MAKE SURE THE POWER IS TURNED OFF before starting the installation.

1. Measure, locate fixture’s position, and mark locations for the brackets.

2. Secure brackets to ceiling as shown below. (HARDWARE BY OTHERS)

3. Wiring fixture to power supply, shall be performed by a certified electrician, and wired in a manner that

complies with all local and national electrical codes, as well as the manufacturer’s wiring diagram.

4. Proper replacement of a part removed for user manintenance.

HT UNV

WIRING

Beghelli U.S.A., 3250 Corporate Way, Miramar, Florida, Tel: [phone] Tel: [phone] Fax: [phone]

Page 1 of 3

9/16/2019

A

A.

Using a at head screwdriver,
push-in to release lock (repeat
for 3 other clips).

REMOVING LENS

(HARDWARE BY OTHERS)

(2) 1/2” TRADE SIZE KNOCK-OUTS

REMOVING ELECTRICAL ASSEMBLY

C

B.

Using a at head screwdriver,
twist to release lock (repeat
for 3 other clips).

B

C.

Install back plate on the wall
at designated location (hard-

ware by others).

Beghelli U.S.A., 3250 Corporate Way, Miramar, Florida, Tel: [phone] Tel: [phone] Fax: [phone]

9/16/2019Page 2 of 3

MOUNTING POSITIONS

CEILING MOUNT LED POSITIONWALL MOUNT LED POSITION

Beghelli U.S.A., 3250 Corporate Way, Miramar, Florida, Tel: [phone] Tel: [phone] Fax: [phone]

9/16/2019Page 3 of 3