Bedrug TRAILERWARE User Manual

Installation

TWINST Rev. 1 1/26/2012

Page 1 of 4

Guide

TrailerWare

Fabric

48” wide

Material quantity varies according to kit size.

TM

Trim Rails

8’ lengths

Bag of

Screws

Heavy

Duty

Adhesive

TrailerWare Premium Wall Protection is a great way to give your trailer
a professional, finished look. TrailerWare’s universal design provides
a custom installation to accommodate trailer accessories such as lighting
and cabinets.

Before beginning, read all instructions and have the following tools handy:

Tape measure, pencil, chalk line, flathead or Phillips screwdriver, or drill driver
w/bits, saw (for cutting aluminum trim rails if necessary), and a utility knife.

Please contact TrailerWare Customer Service: 866-210-7457 if you have any
questions regarding components or installation.

FIGURE 1

factory trim

Remove
below 48”
line

Sidewall Installation

1. Disconnect electrical power supply to your trailer

(if equipped).

2. Remove any electrical switches, outlets, brackets,
shelving... etc located in the surface areas to be
covered with TrailerWare material.

3. Measure 48” up from the floor in several places along the

sidewall and mark with a pencil. Use pencil marks as a
guide to snap a chalk line at the 48’ height. (FIGURE 1)

4. Remove any factory trim that may interfere with installing
the aluminum rails or wall covering. This will ensure the
aluminum trim will be able to be mounted flat against the
wall. (FIGURE 2)

Note: In some installations, it may be necessary to remove the entire
factory trim piece, cut with a saw at the chalk line, and reinstall later
above TrailerWare wall covering.

5. Install the aluminum trim rails below the chalk line, with the

screws provided. The channel must be installed with the
open side down, and the long flange flat against the wall.

(FIGURE 3)

Note: Trim Rails can be cut, as necessary, to install around switches

and other trailer features. (below)

FIGURE 2

FIGURE 3

TWINST Rev. 1 1/26/2012

Page 2 of 4