Bedrug BED LINERS User Manual

BedRug Bedliner Installation Instructions

Preparation

Part Number(s): Multiple

Kit Contents

Item # Quantity Req’d. Description

1 1 BedRug floor/tailgate assy
2 1 BedRug bulkhead/sidewall assy
3 1 Hardware kit

Additional Items Required For Installation

Item # Quantity Req’d. Description

Recommended Tools

Personal & Vehicle
Protection

Safety Glasses
Gloves

Special Tools Notes

Tool required to remove tie

Installation Tools Notes

Utility Knife Use to cut slits or trim

Awl Use to locate tie down

Special Chemicals Notes

Approved cleaner Rubbing Alcohol

Notes

downs (unique to vehicle)

BedRug for cargo mgmt.
systems

fasteners. Holes to be placed
in BedRug

WARNING: IMPROPER INSTALLATION
WILL RESULT IN LINER FLYING OUT OF
THE TRUCK. FOLLOW INSTRUCTIONS
EXACTLY.
IMPORTANT: Never cut or put slits through
any seams or sewn areas of the BedRug, unless
specifically detailed in these instructions. This
will cause the seam to come completely apart.

General Applicability

Multiple

Legend

STOP: Damage to the vehicle may occur. Do not
proceed until process has been complied with.

OPERATOR SAFETY:

injury.

CAUTION:

in order to reduce the risk of damage to the
accessory/vehicle and to ensure a quality installation.

TOOLS & EQUIPMENT:

and equipment recommended for this process.

A process that must be carefully observed

Use caution to avoid risk of

Calls out the specific tools

BRINST Rev. Level: 15 12/4/2009 Page 1 of 6

BedRug Bedliner Installation Instructions

Procedure

This document covers such items as:

• Vehicle Preparation (use of cleaners, adhesive promoters, etc.).

• Safety (rechecking torque procedure, etc.).

• BedRug installation.

Fig. 3-1

1. Check Kit Content.

(a) Verify that the kit contains all the parts listed in the

Kit Contents.

2. Vehicle Preparation.

(a) Wash and Dry the Bed and Tailgate areas thoroughly.
(b) IMPORTANT: Review all instructions before

beginning installation. Truck bed should be at least
68°F (20°C) for maximum adhesion. Clean all areas
with an approved cleaner before applying tape. Do not
remove backing from any tape until ready to adhere to
the truck bed. When removing backing, do not t ouch
adhesive. Extra adhesive strips have been provided in
the kit for future use or if the installer deems more
fasteners are necessary for better fit/appearance.

3. Pre-assemble BedRug.

(a) Align the sides of the BedRug as shown. NOTE:

Fig. 3-2

Utility Knife

BEDRUG FLOOR IS FACE DOWN FOR THIS
OPERATION. (Fig 3-1)

(b) Once properly aligned, zip sides into place. (Fig 3-2)

4. Pre-fitting BedRug.

(a) Before preceeding with installation, verify whether or

not the bed of the vehicle has a bedrail cargo
management system installed.

(b) If a bedrail is present, trim off sections in the corners

of the bulkhead. (Fig. 4-2) If not, proceed with step 5.

Fig 4-2

BRINST Rev. Level: 15 12/4/2009 Page 2 of 6