30-32 Garner Place
Ingleburn 2565 NSW
www.be-bella.com.au
Designed in Australia
Made in China
Professional Products Division
Follow us on Facebook
and win free products.
OPERATING INSTRUCTIONS
Notes Before Using
Before using your new Be Bella™ One20 Turbo Clipper for the
first time, please read these instructions carefully.
Charge 90 minute fully to activate the inside rechargeable
batteries. The box should contain:
- 2 attached combs: 3, 6, 9, 12 (mm).
- Only one copy of the Operating Instruction Booklet, please
store it safely and securely so you will always have it when
needed.
Parts Identification:
1. Main unit
2. Switch Button
3. Display
4. Blade
5. Adjustable Lever
6. Comb Attachment
7. Adaptor
8. Brush
9. Oil
10. Stand/Charging Unit
HOW TO USE:
This hair clipper can be used in both cord and cordless.
1. Put the adaptor connected with the jack of battery pack
which lies at the bottom of the machine, then put the adaptor
pins connected with power (pay attention to the voltage, please
coincide with the voltage on the name plate of adaptor), the full
charging time is 2 hours. It can also be charged with charging
stand connected with the bottom of clipper. When fully
charged, it can be used continuously for more than 120
minutes. The indicator lamp will display while charging.
2. Press the switch button slightly before using. If not enough
battery, please charge with adaptor.
HOW TO INSTALL/UNINSTALL THE BLADE
1. To install, please aim the blade at
slot for install, then press the full
parts until hearing the “click” sound.
2. To uninstall, handing the hair clipper
in obverse, then pull the blade
slightly out of the body for uninstall.
HOW TO USE THE COMB ATTACHMENT
1. Please aim the comb feet at column
nails of body sides and make 90°
angle with the blade underside, then
assemble it.
2. Pull the comb feet out of the body
for uninstall.
MAINTENANCE OF THE BLADES
1. Push the blade out of the machine, then use the cleaning brush
to wipe off the scraps among the blade. Lubricate the space
between the stationary and the moving blades with 2 or 3
drops of oil .
2. Clean the blade everytime after use.
CHARGING
Please don’t charge if the temperature is lower than 0°C or
higher than 40°C. Please don’t charge if it is nearby the sunlight
perpendicular incidence or the heat source radiates.
The standard charging time is 2 hours. In order to avoid
mangling the batteries, please don’t extend the charging time.
CAUTIONS
Clean the housing using only a cloth that is slightly dampened with
water or a mild soap solution. Never use a caustic solution. Never
submerge the clipper in water. Keep away from the children.
This clipper may become warm during operating and/or
charging, this is normal. When holding the clipper, don’t hold the
power soft line, in order to prevent possible harm to soft line and
to avoid accidents. Never tamper with moving parts.
TECHNIC DATA
Rating voltage: 3, 7 V
Charging time: 2 hours
This appliance is not intended for use by persons (including
children) with reduced physical, sensory of mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety; Children should be
supervised to ensure that they do not play with the appliance.
To prevent possible harm to the environment or human health
from uncontrolled waste disposal, such as the unused batteries
and motors etc, recycle them responsibly to promote the
sustainable reuse of material resources. To return your used
device, please use the return and collection systems or contact
the retailer where the product was purchased. They can take
this product for environmental safe recycling.
Loading...