Page 1
153.705 V1
WHIRLWIND
Page 2
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to
this, all other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and
may be used. No dimmer or adjustable power supply.
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground
to avoid the risk of electrocution or fire.
The unit may be set up on a stable and even surface. By means of the fixing facilities of the baseplate, the unit can also be mounted upside down to
a truss, see below picture. For fixing, certified clamps with correct save working load are required. According to the figure, the quick lock bolts of
the omega brackets are placed into the openings provided in the base plate and turned clockwise until they lock (to the stop). The mounting place
must be of sufficient stability and be able to support a weight of 10 times of the unit’s weight. Secure the unit with a safety cable so that it cannot
fall down.
When carrying out any installation, always comply European and national guidelines concerning rigging, truss and all other safety issues. Always let
the installation checked out by an authorized dealer !
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the first unit in a DMX
chain. Always connect the output of one unit with the input of the next unit until all units are connected.
At the last unit, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor
between signal (-) and signal (+) and connect it to the DMX output of the last unit in the line.
Page 3
ON
OFF
DMX Mode
Auto Running Mode
Auto Running Speed up
Auto Running Speed down
Sound Control Mode
Sound Sensitive +
Sound Sensitive -
Red
Green
Blue
White
UV
DMX address setting
Internal program 1-9
Auto program
Internal sound program
Sound program, 1-9 means sensitive
1
Pan
000-255
0-540degree movement
2
Tilt
000-255
0-180degree movement
3
Pan/Tilt Speed
000-255
Pan/Tilt Speed from fast to slow
4
Lens Wheel Rotation
000-127
0-360degree rotate
128-191
Forward endless rotate from slow to fast
192-255
Reverse endless rotate from slow to fast
5
Dimmer
000-255
Linear dimmer from dark to brighter
6
Strobe
000-009
No function
010-255
Strobe from slow to fast
7
Red
000-255
Red dimmer from dark to brighter
8
Green
000-255
Green dimmer from dark to brighter
9
Blue
000-255
Blue dimmer from dark to brighter
10
White
000-255
White dimmer from dark to brighter
11
Mode
000-050
CH1-CH10 Valid
051-150
Random Auto Running
150-255
Sound Control
12
Reset
000-250
None
251-255
Reset after 3s
Page 4
Loading...