Page 1
153.220 V1
JB60R Jelly Ball
Page 2
The mounting place must be of sufficient stability and be able to support a weight of 10 times of the unit’s weight. Secure the unit with a safety cable so
that it cannot fall down.
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the first unit in a DMX chain.
Always connect the output of one unit with the input of the next unit until all units are connected.
At the last unit, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor
between signal (-) and signal (+) and connect it to the DMX output of the last unit in the line.
ON / OFF
DMX mode ON / OFF
Pause/Start auto program or sound program
Sound program S1
Sound program S2
Sound program S3
Strobe ON/ OFF
Auto program, chose A1, A2, A3, A4, A5, A6, A7
Increase or decrease speed
The remote control is supplied with a battery inserted. An insulating
foil between the battery and the battery contacts prevents the battery from being
discharged during storage. Prior to the first operation remove the foil from the
battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
For operation, one 3 V button cell type CR 2025 is required. When inserting, pay attention
that the positive pole of the button cell shows upwards in the support.
Page 3
Red + Yellow mode
Green + Purple mode
Blue + White mode
Always light on
Two colour mode
Four colour mode
Auto program
Sound control, fast program
Sound control, slow program
DMX address setting
1
Master dimmer
000-255
Total brightness gradually from darkness to brightness
2
Colour
000-255
Red + yellow led dimming, from 0-100%
3
000-255
Green + purple led dimming, from 0-100 %
4
000-255
White + blue led dimming, from 0-100%
5
000-255
Strobe slow to fast
Page 4
Loading...