HIGH PERFORMANCE
FURNITURE FOR YOUR
HOME THEATER
DeployTM
Assembly Instructions
Deploy™ Home Theater Furniture
Your Deploy
™
Home Theater Furniture
is engineered for easy assembly.
Carefully follow this procedure to
prevent any damage.
Placement and Maintenance
Deploy™ Home Theater Furniture
is designed for indoor use on level
floors. Clean glass with glass cleaner,
and steel parts and wood veneer with
a moist cloth.
Designed by BDI Design Studio.
These distinctive product congurations
are protected by US and international
patents, trade dress, and/or copyright
laws. “Deploy” and BDI are trademarks of
Becker Designed Inc. All Rights reserved.
©2005, BDI
Center Shelf Support x 1
Assembled Frame x 1
Top Glass Shelf x 1
Sliding Back Panel x 1
Center Glass Shelf x 2
Rubber Bumper Insert x 15
Allen Wrench x 1
Shelf Pin x 4
Threaded Knob x 4
Velcro Strap/Wood
Screws x 9
Step 1
Unpack and identify the parts listed above.
The assembly workspace should be a non-marring surface such as carpet. If any parts are missing or damaged contact: BDI
Customer Service at customerservice@bdiusa.com
Unfold the metal legs on the assembled frame. Install the shelf pins into the desired location on the folding metal legs and the
inside area of the wood frame using the allen wrench. Install the rubber bumper inserts to the assembled frame.
Step 2
Insert back panel. Once the metal legs are opened,
slide the back panel down into the “U” channel, and
tighten the four threaded knobs to secure back panel
into position. Note* threaded knobs are included with
the assembled frame.
Step 3
First, install the rubber bumper inserts to all of the hole
locations on the center shelf support. Second, install the
center glass shelf support by placing on the previously
installed shelf pins. Third, install the glass shelves.
Step 4
Velcro straps and small wood screws are
supplied, and can be used for organizing cable
management. On the rear side of the back
panel, are 9 pre-drilled holes for installing the
Velcro straps using a Phillips screw driver.
Double Wide TV Stand Model 9624 Cherry
19” H x 49” W x 19.5” D
For at panel TVs up to 50”, or rear projection TVs up to 45”.
Double Wide TV Stand Model 9634 Espresso
19” H x 49” W x 18.5” D
For at panel TVs up to 50”, or rear projection TVs up to 45”.
Triple Wide TV Stand Model 9629 Cherry
19” H x 61” W x 19.5” D
For at panel TVs up to 62”, or rear projection TVs up to 62”.
Triple Wide TV Stand Model 9639 Espresso
19” H x 61” W x 18.5” D
For at panel TVs up to 62”, or rear projection TVs up to 62”.
Loading...