BDI 9760 User Manual

HIGH PERFORMANCE

FURNITURE FOR YOUR

HOME THEATER

TM

Aspect

9760

Assembly Instructions

Aspect™ Home Theater Furniture

Your Aspect
for easy assembly. Carefully follow this procedure to
prevent any damage.

Placement and Maintenance

Clean steel parts with a moist cloth.

Designed by Louis A. Lara

‘Aspect’ is a trademark of Becker
Designed, Inc. All rights reserved.
©2005 Becker Designed, Inc.

™

Home Theater Furniture is engineered

Universal Mounting Bar (UMB) x 2

Glass Shelf x 1

Shelf Bracket x 1

UMB Cover Plate x 1

Column x 1

Base x 1

Ballast x 1

UMB Mounting Plate x 1

Bubble Leveler x 1

M4, M5, and M8 Allen Wrench

B - M6 x 10mm x 4

C - M8 x 12mm x 2

A - M10 x 40mm x 1

D - Button Head Screw x 2

Lock Washer x 2

Step 1

Unpack and identify parts listed on the previous page.

The assembly workspace should be a non-marring surface such as carpet. If any parts are missing or damaged contact BDI
Customer Service at: [e-mail]

1.

2.

B x 4

Install shelf bracket near the center of the column
area, near the center cable management hole. Use part
B, and M4 allen wrench to attach the shelf bracket.

3.

D x 2

A

Install Column. Insert the column into the top opening

of the base. By laying these parts on their side, install
the ballast to the bottom of the base using the part A
and the M8 allen wrench.

Wire Management. Once the unit is assembled, and
the TV is ready for mounting, guide all wires connecting
from the component to the TV (including power cords)
through any of the three cable management holes
provided.

Install glass shelf to the shelf bracket using part
D, lock washer and M5 allen wrench.

4.

C x 2

4. Install UMB mounting plate to the top of the
column using the part C, and M5 allen wrench.

Step 5

Install UMB Bars. Find mounting screws that came with

your flat screen TV. If screws are not available, find the
short Phillips head mounting screws provided with Aspect
(provided in the second blister pack) that thread cleanly into
the mounting holes in the back of your TV. The following
thread sizes are included: M4, M5, M6, and M8. Attach
both UMB bars to TV as shown using washers and
Phillips screwdriver. Note: If back of TV has a curved
surface, or, if bars do not sit flat, use spacers and long
mounting screws provided. Make sure UMB bars are
centered left to right! Fully tighten bars to TV!

6.

Install TV at desired height near by inserting the

threaded studs into key holes. Note* Nuts are pro­vided in the second hardware blister pack and must be
threaded on the studs of the top UMB bar in order to
prevent any damage to the TV.

8.

Install the second set of nuts to the threaded studs

of the bottom UMB bar. Use Bubble Leveler
provided to ensure that TV is level. Once leveled, fully
tighten all of the nuts!

7.

Once the threaded studs are positioned through the
key holes and slots, lower the TV into resting position.

9.

Install UMB cover plate by sliding it over the top of

the UMB face plate.