®
De p l o y
9621 and 9631
a s s e m b l y i n s t r u c t i o n s
b d i u s a .c o m c u s t o m e r s e r v i c e @b d i u s a .c o m
Component List
A - Assembled Frame x 1
B - Glass Shelf Clip /
Screw
x 2
C - Back Panel x 1
Deploy® is engineered for easy assembly. Carefully follow this
procedure to prevent any damage.
Placement and Maintenance
®
Deploy
is designed for indoor use on level floors. Clean glass with
glass cleaner, and steel parts and wood veneer with a moist cloth.
Step 1
Unpack and Identify
Unpack and identify the components at left. The assembly
workspace should be a non-marring surface such as carpet. For
missing hardware pieces, please contact BDI Customer Service
at customerservice@bdiusa.com. For all other concerns, please
contact your BDI Retailer.
Step 2
Unfold the metal legs on the Assembled Frame (A).
D - 20mm Back Panel
Shelf Pin
x 2
E - Glass Shelf Pin x 6
F - 10mm Shelf Pin x 4
G - Shelf Bracket
x 2
H - Rubber Bumper Insert
x 11
I - Center Glass Shelf x 3
J - Top Glass Shelf x 1
K - Velcro Strap and
Wood Screw
x 8
Step 3
Install Glass Shelf Clip (B) to the rear side of unfolded metal leg
using the supplied Allen Wrench (L2). Do not tighten set screws
until glass shelf is installed during Step 5.
L1 - Allen Wrench x 1
L2 - Allen Wrench x 1
Designed by by BDI Design Studio.
These distinctive product configurations are protected by US and international
patents, trade dress, and/or copyright laws.
“Deploy” and BDI are trademarks of Becker Designed, Inc.
All Rights reserved. ©2009, BDI
Made in China. 96219631REV012210v3
B
1
Step 4
Install back panel
Install Back Panel (C) using the Back Panel Shelf Pin (D) and
Allen Wrench (L1). Install Glass Shelf Pin (E) to desired height
location on Back Panel (C) using a flat head screw driver.
D x 2
E x 6
Step 5
Installing the Shelf Brackets and Rubber Bumper Inserts
Install Shelf Pin (F) using Allen Wrench (L1). Install Shelf
Brackets (G) on previously installed Shelf Pin (F). Once Shelf
Brackets (G) are in place, install Rubber Bumper Inserts (H) in
all visible hole locations.
F x 4
H x 11
2
a s s e m b l y i n s t r u c t i o n s
b d i u s a .c o m c u s t o m e r s e r v i c e @b d i u s a .c o m
Step 6
Install the glass shelves
Install Center Glass Shelves (I) and Top Glass Shelf (J). Tighten
set screws on bottom of Glass Shelf Clip (B) to keep Top Glass
Shelf (J) from sliding out of position, then tighten both machine
screws on back of Glass Shelf Clip (B).
J
I
Step 7
Cable Management
Velcro Straps and Wood Screws (K) are supplied, and can be
used for organizing cable management. On the rear side of the
back panel are pre-drilled holes for installing the Velcro Straps
(K) using a Phillips screw driver.
K x 8
3
a s s e m b l y i n s t r u c t i o n s
b d i u s a .c o m c u s t o m e r s e r v i c e @b d i u s a .c o m
Loading...