sonda
8656
a s s e m b l y i n s t r u c t i o n s
bdiusa.com cust omerservice@bdiusa.com
Component List
A - 3 mm Hex Wrench
x 1
B - 4 mm Hex Wrench
x 1
C - Rubber Bumper
x 3
D - 1/4-20 x 1/2"
Machine Screw
x 6
E - 3/16 x 13 mm
Machine Screw
x 2
F - 1/4-20 x 15 mm
Machine Screw
x 12
Sonda is engineered for easy assembly. Carefully follow this
procedure to prevent any damage.
Placement and Maintenance
Sonda is designed for indoor use on level floors. Clean wood
veneer with a moist cloth. Clean glass with glass cleaner.
Step 1
Unpack and Identify
Unpack and identify the components at left. Note that some
components are shipped inside the cabinet. The assembly
workspace should be a non-marring surface such as carpet. For
missing hardware pieces, please contact BDI Customer Service
at customerservice@bdiusa.com. For all other concerns, please
contact your BDI Retailer.
G - Glass Top
x 1
H - Top Support
x 1
I - Front Frame
x 1
J - Rear Frame
x 1
K - Cabinet
x 1
M - Back Panel
x 2
G
H
J
K
I
Designed by Noah Packard.
These distinctive product congurations are protected by US and
international patents, trade dress, and/or copyright laws.
BDI are trademarks of Becker Designed, Inc.
All Rights reserved. ©2012, BDI
Made in China. 8656REV1010213v1
1
Step 2
Build Base Assembly
Using Hex Wrench (B) and Screw (D), install the Top Support (H)
to the Front Frame (I) and Rear Frame (J).
D
D
D
D
J
D
D
H
I
Step 3
Carefully lay Cabinet (K) front-side down. With the help of
another person, carefully lower base assembly over Cabinet (K).
J
I
sond a
86 56
2
K
ass embly instruc tion s
bdiusa.com customerservice@bdiusa.com
Step 4
Using Hex Wrench (B), attach the base assembly to the bottom of
Cabinet (K) with Screw (F). Use Hex Wrench (A) for Screw (E).
*Note: Front and rear frames have adjustable levelers.
F
F
E
E
F
F
E x 2
F
F
K
F x 8
Step 5
Install Glass
Place assembled cabinet right-side up and install Rubber Bumper (C).
Install Glass Top (G) on assembled cabinet. Attach glass with Screw (F).
C
F
F
C
C
F
F
G
F
F
sond a
86 56
3
ass embly instruc tion s
bdiusa.com customerservice@bdiusa.com
Step 6
Install Back Panels
Install both Back Panel (M) to the backside of the cabinet by inserting top
edge in upper channel, then tipping bottom edge forward and into lower
channel.
NOTE: Velcro straps are included as wire management for your convenience.
2
1
sond a
86 56
4
ass embly instruc tion s
bdiusa.com customerservice@bdiusa.com
Loading...