
1
B1 - Hex Driver x 1
B2 - Hex Wrench x 1
Sweep is engineered for easy assembly. Carefully
follow this procedure to prevent any damage.
Placement and Maintenance
Sweep is designed for indoor use on level floors.
Clean wood veneer with a moist cloth. Clean
glass with glass cleaner.
Step 1
Unpack and Identify
Unpack and identify the components at left. Note that some
components are shipped inside the cabinet. The assembly
workspace should be a non-marring surface such as clean carpet.
For missing hardware pieces, please contact BDI Customer Service
at customerservice@bdiusa.com. For all other concerns, please
contact your BDI Retailer.
Component List
Designed by Louis A. Lara.
These distinctive product congurations are protected by US and
international patents, trade dress, and/or copyright laws.
BDI are trademarks of Becker Designed, Inc.
All Rights reserved. ©2015, BDI
Made in China. 8438REV083115v1
sweep
8438
cabinet
assembly instructions
bdiusa.com customerservice@bdiusa.com
C - 1/4-20 x 70 mm
Screw x 2
D - 1/4-20 x 15 mm
Screw x 16
E - Cabinet x 1
F - Metal Leg x 2
G - Wood Leg x 1
HL - Adjustable Shelf x 1
HR - Adjustable Shelf x 1
IR - Adjustable Shelf x 1
IL - Adjustable Shelf x 1
J - Back Panel x 2
J
E
HL
HR
IR
C
D
F
G
F
D
IL

usa.com customerservice@bdiusa.com
sweep
Step 2
Build Base Assembly
With the help of another person, position the cabinet on its back. Attach Metal Legs (F)
to Cabinet (E) using Screws (D) and tighten with Hex Driver (B1). Attach Wood Leg (G)
to Cabinet (E) using Screws (C) and tighten with Hex Driver (B1).
Step 3
Turn Cabinet Over and Install Back Panels
With the help of another person, position the cabinet right side up. Install Back Panels
(J) to the backside of the cabinet by inserting top edge in upper channel then tipping
bottom edge forward and into lower channel.
NOTE: Velcro straps are included for your convenience to facilitate wire management.
TWO PERSON ASSEMBLY
TWO PERSON ASSEMBLY
C x 2
D x 16
G
E
F
F
D
D
D
D
C
C
B1
J
1
1
2
2