Page 1
ASSEMBLY INSTRUCTIONS
OLA
8137
Placement and Maintenance
OLA 8137 is designed for indoor use on level floors. Clean glass with glass cleaner, and wood veneer with a moist cloth.
BDIUSA.COM CUSTOMERSERVICE@BDIUSA.COM
Component List
OLA 8137 is engineered for easy assembly. Carefully follow this procedure to prevent any damage.
Unpack and identify the components. The assembly workspace should be a non-marring surface such as clean carpet.
Use a blanket on the floor to protect cabinet during assembly.
For missing hardware pieces, please contact BDI Customer Service at customerservice@bdiusa.com.
For all other concerns, please contact your BDI Retailer.
A - 4mm Hex Driver x 1
To Attach Base Legs
B - Phillips Screwdriver x 1
To Adjust Doors
C - 1/4-20 x 25mm
Screw x 16
D - 1/4-20 x 60mm
Screw x 2
E - Cabinet x 1
F - Metal Leg x 2
G - Wood Leg x 1
H - Glass Shelf x 1
I - Wood Shelf x 2
J - Back Panel x 2
E
F
I
C
H
G
D
J
I
J
F
C
Designed by Louis A. Lara
These distinctive product configurations are protected by US and international
patents, trade dress, and/or copyright laws.
BDI are trademarks of Becker Designed, Inc.
All Rights reserved. © 2011 BDI
OLA 8137 Rev: 06-28-11
1
Page 2
Step 1
With the help of another person, position the cabinet on it's back.
Attach
Attach
Metal Legs (F) to Cabinet (E) using Screws (C) and tighten with Hex Driver (A).
Wood Leg (G) to Cabinet (E) using Screws (D) and tighten with Hex Driver (A).
F
C
A
G
Recommended
2-person Step
Step 2
Turn Cabinet Over and Install Back Panels
With the help of another person, position the cabinet right side up.
CAUTION: Do Not Turn Cabinet Over on the Doors.
Install Back Panels (J) to the back side of the cabinet by inserting top edge in
upper channel, then tipping bottom edge forward and into lower channel.
Recommended
2-person Step
D
OLA
8137
J
J
2
ASSEMBLY INSTRUCTIONS
BDIUSA.COM CUSTOMERSERVICE@BDIUSA.COM
Page 3
Step 3
Adjust Levelers as necessary
2 levelers for each
Metal Leg (F) and 1 Leveler for Wood Leg (G).
A
A
F
Step 4
Adjust Door Hinges as necessary
Phillips Screwdriver (B) adjust hinges as shown below
Using
G
OLA
8137
Loosen screws on hinge plate
to adjust door up or down
B
Turn screw to adjust door in or out from cabinet
Turn screw to adjust door tilt
3
ASSEMBLY INSTRUCTIONS
BDIUSA.COM CUSTOMERSERVICE@BDIUSA.COM
Loading...