BDI CENTRO, 6414 Assembly Instructions Manual

CENTROTM 6414

3-DRAWER FILE CABINET

bdiusa.com

[e-mail]

Product Registration

Registering your new BDI product allows us to send you important
product updates, service information and helpful hints related to your
BDI products. Register today, and you will be entered to win free a BINK
table from BDI. www.bdiusa.com/product-registration/

Placement and Maintenance

Centro™ Office furniture is designed for indoor use on level floors. Clean
glass with glass cleaner, and steel parts and wood veneer with a moist
cloth.

Your Centro™ Office furniture is engineered for easy assembly. Carefully
follow this procedure to prevent any damage.
Do not use power tools for assembly of this product.

Step 1

Unpack and identify the parts listed below. The assembly workspace
should be a non-marring surface such as carpet. For missing hardware
pieces, please contact BDI Customer Service at customerservice@
bdiusa.com. For all other concerns, please contact your BDI retailer.

C1 Glass Panel x 1

T1 4mm Hex Wrench

H1 1/4-20 x 15mm

Screw x 16

H2 M4 x 37mm
Screw x 6

H3 1/4-20 x 19mm
Screw x 3

H4 Bumper x 2

C2 Pull x 3

C4 Small File Bar x 1

Designed by Matthew Weatherly.
These distinctive product configurations are protected by US and international patents, trade dress, and/or
copyright laws. Centro & BDI are trademarks of Becker Designed, Inc. All rights reserved. ©2015, BDI
Made in China. 02.16.2016 V2

A1 Cabinet x 1

C3 Base x 2

C6 File Bar Clip x 2

Tool Required:

Phillips screwdriver

Step 2 - Lay Cabinet on its back side. Attach Base to Cabinet using Screws H1 and tighten with Hex
Wrench.

H1 (x16)

Step 3 - Adhere Bumpers H4 as shown.

H4 (x2)

2

CENTRO 6414
3-DRAWER CABINET

bdiusa.com

[e-mail]