BDI 1501G User Manual
a s s e m b l y i n s t r u c t i o n s
St r e a m
1501G, 1502G, 1510G & 1523G
1510G
1501G 1502G
b d i u s a .c o m c u s t o m e r s e r v i c e @b d i u s a .c o m
1523G
Component List
A - Allen Wrench x 1
B - Glass Top x 1
C - Metal Leg x 2
D - Socket Screw x 4
E - Lower Wood
Shelf x 1
Stream is engineered for easy assembly. Carefully follow this
procedure to prevent any damage.
Placement and Maintenance
Stream is designed for indoor use on level floors. Use damp cloth to
clean steel parts. Clean wood veneer with a moist cloth. Use mild soap
on a damp rag to remove difficult stains. DO NOT use ammonia-based
glass cleaner to clean glass parts, doing so may damage finish on
legs.
Step 1
Unpack and Identify
Open boxes, but DO NOT REMOVE SHELVES.
Unpack and identify the components at left. The assembly workspace
should be a non-marring surface such as carpet. For missing
hardware pieces, please contact BDI Customer Service at
customerservice@bdiusa.com. For all other concerns, please contact
your BDI Retailer.
Step 2
Attach Legs to Glass Top
Using the illustration as a guide, attach the Metal Legs (C) to the
Glass Top (B) as shown using the Socket Screw (D) and Allen Wrench
(A). This shold be done BEFORE removing top from the box so that
Glass Top (B) is not scratched prior to assembly.
F - Long Socket
Screw x 4
F
Designed by Cristian Wicha.
These distinctive product configurations are protected by US and international
patents, trade dress, and/or copyright laws.
BDI is trademark of Becker Designed, Inc.
All rights reserved. ©2010, BDI
Made in China. 1501150215231510REV03182010v2
1
Step 3
Prepare to attach Wood Top
Carefully rotate 90 degrees so that the table is resting on its side ona
non-marring surface. For easiest installation find a paperback book
about 1” thick and place on floor between Metal Legs (C) as shown
below,or find non-abrasive materials to temporarily cover inside edge
of legs.
Step 4
Attach Wood Top
Carefully slide Lower Wood Shelf (E) into place being careful not to
bump the Metal Legs (C). Rest the Lower Wood Shelf (E) on the book
and attach using the Long Socket Screw (F) and Allen Wrench (A).
Paperback book
1” thick
2
a s s e m b l y i n s t r u c t i o n s
b d i u s a .c o m c u s t o m e r s e r v i c e @b d i u s a .c o m
Loading...