INSTRUCTION
MANUAL
Masticating Extractor Juicer
Ver. 1
SKY4890
NOTICE
• Do not allow children to operate this appliance. Keep appliance out of reach of children.
• Place appliance on a stable and level surface.
• This item is intended for indoor, household use only.
• Using an extension cord is not recommended as it may overheat and cause a risk of fire.
• Ensure that your voltage is consistent with specifications.
• Do not plug appliance into the same circuit as other appliances.
• Routinely check if the appliance or power cable is damaged.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
• If any parts are missing, broken, damaged, or worn, stop using this product until repairs are made
and/or factory replacement parts are installed.
• Do not use this item in a way inconsistent with the manufacturer’s instructions as this could void the
product warranty.
Please retain these instructions for future reference.
WARNING
• Keep appliance away from direct sunlight and other sources of heat (stove, heater, etc.).
• Do not run power cord over sharp edges/corners or a hot surface.
• Do not put the appliance in water or any other liquid.
• Do not spill water on the electrical components or connectors.
• Do not operate appliance with wet hands.
• Do not unplug the appliance by pulling on the power cord. Always grasp the plug firmly and pull straight
out from the outlet.
• Do not insert your hand or other objects into the appliance during operation.
• Do not move this appliance or touch any of its components while it is in motion.
• Always wait until parts come to a complete stop before removing accessories.
• Do not use if the plug or any components are damaged.
• Do not use any accessory or fitting other than original accessories and fittings.
• Do not use this appliance with an external switching device or timer.
• Before plugging appliance into wall outlet, make sure the power switch is o. Switch o appliance
before unplugging.
• Switch o and unplug appliance if it is left unattended and before assembly, disassembly, or cleaning.
• Switch o and unplug appliance after each use and before changing accessories or handling parts.
SPECIFICATIONS
Voltage
Power
Pg. 2
120 Volts, 60 Hz
150 watts
ACCESSORIES
BRUSH
PARTS
A
MOTOR UNIT
D
BASKET
1 PC
1 PC
B
SEPARATOR
E
SCROLL
1 PC
1 PC
1 PERSON
ASSEMBLY
C
BASKET SUPPORT
F
HOPPER
APPROXIMATELY
5 MIN.
ASSEMBLY
1 PC
1 PC
G
PUSHER
1 PC
H
JUICE/PULP PITCHER
2 PCS
I
FILTER
1 PC
Pg. 3
POWER SWITCH
SEPARATOR
Pulp dispensing spout
ON
OFF
R
SIDE
Silicone Seal
BOTTOM
On
O
Reverse
Juice dispensing spout
Anti-drip cap
Pulp plug
BEFORE FIRST USE
1. Remove all packaging and accessories.
2. Wash parts with warm water, mild detergent, and a soft cloth.
3. Wipe down motor unit with warm water and a soft cloth.
4. Thoroughly dry all parts.
5. Place appliance on a stable and level surface. Make sure power switch is in OFF position.
Pg. 4
PRODUCT ASSEMBLY
Insert the part B separator into the
part A motor unit. Turn the separator
1
clockwise to lock it in place.
B
Insert the part D basket into the part C
basket support.
2
Line up the red dots on the basket with
the separator, then insert the basket into
the separator.
Insert the part E scroll into the basket
until it locks into place.
E
D
Make sure the silicone seal
and pulp plug underneath
the separator are properly
inserted and installed.
C
A
Pg. 5
PRODUCT ASSEMBLY
Line up the red dots on the part F
hopper with the separator, then
3
place the hopper. Turn the hopper
clockwise to lock it in place.
F
Insert the part G pusher into the funnel of
the hopper. Place the part H juice and pulp
5
pitchers in their designated place under the
juice and pulp spouts.
G
4
Pg. 6
Insert the part I filter into a part H
pitcher. This pitcher is the
designated juice pitcher.
I
H
Juice pitcher (with filter)
H
x2
USAGE TIPS
• Appliance includes sharps parts. Take extreme care when handling parts during assembly, disassembly,
or cleaning.
• Do not use the appliance empty or unloaded.
• Do not use appliance if the basket is damaged.
• Remove seeds and pits from fruits and vegetables before juicing.
• If using frozen fruit, always add juice or milk.
• Never push food with hands or other utensils; always use the provided pusher.
• Do not allow appliance to operate longer than 1 minute at a time. Appliance must cool for 15-20 minutes
after 1 minute of continuous operation.
• Appliance has a safety lock and cannot operate if it is not correctly assembled.
• This appliance is equipped with overheating protection. If the motor overloads or overheats, the unit will
automatically stop.
• If motor overheats, stop operation for about 15 minutes. Do not operate the appliance until it has cooled.
• Turn o, unplug, and clean after every use.
OPERATING INSTRUCTIONS
1. Cut food into pieces small enough to fit into the funnel of the hopper.
Note: Fruits and vegetables smaller than 3 inches in diameter can be inserted directly into the hopper.
2. Make sure the cap of the juice spout is open. Plug appliance into a wall outlet and turn it on.
3. Use the pusher to push food into the funnel of the hopper. Push food against the blade to make juicing
easier. The juice and pulp are separated automatically.
Note: To dislodge jammed food and/or maximize the amount of juice you get, switch to the R position
to put the basket in reverse.
4. When finished, switch to the OFF position to turn the juicer o. Close the cap of the juice spout and
empty the pitchers.
CLEANING
• Unplug the appliance before cleaning or storage.
• Wash parts with warm water, mild detergent, and a soft cloth.
- Open pulp plug underneath the separator before washing.
• Wipe down motor unit with warm water and a soft cloth.
• Do not clean with steel wool or abrasive detergents.
• Place the parts in a well-ventilated place to dry. Allow parts to thoroughly dry before reassembling
the appliance.
Pg. 7
ASSEMBLY COMPLETE!
PRODUCT WARRANTY INFORMATION
All items can be returned for any reason within 60 days of the receipt and will receive a full refund as long
as the item is returned in its original product packaging and all accessories from its original shipment are
included. All returned items will receive a full refund back to the original payment method. All returned
items will not be charged a re-stocking fee.
All returned items require an RA (Return Authorization) number, which can only be provided by a Best
Choice Products Customer Service Representative when the return request is submitted. Items received
without an RA may not be accepted or may increase your return processing time. Once an item has been
received by Best Choice Products, refunds or replacements will be processed within 5 business days.
All returns must be shipped back to the Best Choice Products Return Center at the customer’s expense. If
the reason for return is a result of an error by Best Choice Products then Best Choice Products will provide
a pre-paid shipping label via email. Boxes for return shipping will not be provided by Best Choice Products,
and is the customer’s responsibility to either use the original shipping boxes or purchase new boxes.
Pictures may be required for some returns to ensure an item is not damaged prior to its return. Items
returned are not considered undamaged until they are received by Best Choice Products and verified as
such. All damages to items are the customer’s responsibility until the item has been received by and
acknowledge by Best Choice Products as undamaged.
CONTACT US; WE’RE HERE 7 DAYS A WEEK TO HELP YOU!
bestchoiceproducts.com customerservice@
bestchoiceproducts.com
844.948.8400
LEARN MORE!
WARNING
Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage or
loss, whether direct, indirect, or incidental, resulting from the incorrect attachment, improper use,
inadequate maintenance, or neglect of this product.
Loading...