INSTRUCTION
MANUAL
Quadcopter with HD Camera
SKY1809Ver. 3
CAUTION
• Ensure that the drone is correctly assembled to prevent any injuries or accidents.
• This product is intended for ages 14 and older.
• This product is recommended for outdoor use or open spaces. Make sure to follow local laws and
regulations regarding drone flight in public areas.
• Do not use this product for any other purpose than its intended use.
Please retain these instructions for future reference.
BATTERY WARNINGS
The following safety hazards may result in serious injury or death:
• Use of a battery or charger other than the supplied rechargeable battery and charger may cause a fire or
explosion. Only use the supplied battery and charger.
• Use of the rechargeable battery and charger for any other product may result in overheating, fire, or
explosion. Never use the supplied rechargeable battery and charger with another product.
• Explosive gases are created during charging. Charge the battery in a well-ventilated area. Do not charge
the battery near heat or flammable materials.
• Contact between the positive and negative terminals may result in fire or explosion. Avoid direct contact
between the terminals. Picking up the battery by the wires or charger can cause damage to the battery
and may result in a fire. Always pick up the battery by its case or handles.
• Liquids on the battery may cause fire or electric shock. Always keep all liquids away from the battery and
keep the battery dry. Contact or exposure to battery leakage (lead acid) may cause serious injury. If
contact or exposure occurs immediately call your physician. If the chemical is on the skin or in the eyes,
flush with cool water for 15 minutes. If the chemical was swallowed, immediately give the person water or
milk. Do not give water or milk if the patient is vomiting or has a decreased level of alertness. Do not
induce vomiting.
• Battery posts, terminals, and related accessories contain lead and lead compounds (acid) – chemicals
known to the State of California to cause cancer, reproductive harm, and are toxic and corrosive. Never
open the battery.
• Tampering or modifying the electric circuit system may cause a shock, fire or explosion and permanently
damage the system. Exposed wiring and circuitry in the charger may cause electric shock. Always keep
the charger housing closed.
TOOLS REQUIRED
PHILLIPS
SCREWDRIVER
(PROVIDED)
HARDWARE
1
LANDING GEAR
SCREW
8 PCS
Pg. 2
2
PROPELLER CAGE
SCREW
8 PCS
1 PERSON
ASSEMBLY
APPROXIMATELY
15 MIN.
ASSEMBLY
PARTS
A
LANDING GEAR
E
MICROSD CARD/
USB READER
2 PC
4GB
1 PC
B
PROPELLER CAGES
F
BATTERY
4 PC
1 PC
C
SPARE PROPELLERS
G
CAMERA
4 PC
1 PC 1 PC
SETTING UP YOUR QUADCOPTER DRONE:
1
1
2
D
USB CHARGING CABLE
1 PC
H
REMOTE CONTROL
2
ON
Install the landing gear onto the bottom of the
quadcopter with four part 1 landing gear screws.
Install the propeller cages onto the corners of the
quadcopter with four part 2 propeller cage screws.
INSTALL CAMERA
1
1. Slide the camera into the designated slot on the battery cover.
2. Open the battery cover.
3. On the underside of the battery cover, secure the camera to the battery cover with two screws.
Then close the battery cover.
4. Insert the 3-pin plug from the camera into the designated slot next to the battery cover.
2 3 4
Pg. 3
PREPARE THE QUADCOPTER FOR FLIGHT
1 2 3 4
ON
1. Turn on the remote control.
2. Open the battery cover on the quadcopter, insert the battery, and plug it into the designated power port.
3. Turn on the quadcopter.
4. Push the left control lever (throttle) to the highest position, and then pull it back to the lowest
position. The remote control will emit a sound indicating that the quadcopter is ready to fly.
OPERATING YOUR QUADCOPTER (MODE 1)
ON
HOVER UP & DOWN: Move the left control lever
(throttle) up or down, and the quadcopter will
gain or lose elevation.
FORWARD & BACKWARD: Move the right control
lever up or down, and the quadcopter will fly
forward or backward.
ON
ON
ON
ROLL LEFT & ROLL RIGHT: Move the left control
lever (throttle) left or right, and the quadcopter
RIGHT & LEFT: Move the right control lever left or
right, and the quadcopter will fly to the left or right.
will roll to the left or right.
FINE-TUNING YOUR QUADCOPTER (MODE 1)
ON
FORWARD/BACKWARD FINE
TUNING: If your quadcopter veers
forward or backward, correct it with the
forward/backward fine tuning button.
LEFT/RIGHT TURN FINE TUNING: If
your quadcopter veers to the left or
right, correct it with the left/right turn
fine tuning button.
ON
ON
ON
LEFT/RIGHT ROLL FINE TUNING: If
your quadcopter rolls too much to the
left or right, correct it with the
left/right roll fine tuning button.
360° EVERSION
• Once you have a general understanding of how to
control the quadcopter you can activate the
360-degree eversion function.
• Fly the quadcopter at a minimum height of 9 feet.
• Press the 360-degree eversion button located on
the top right of the remote control, then move the
right control lever in the direction you wish to flip.
PHOTO & VIDEO
• Turn on the quadcopter. If the lights are flashing green, this means that the
camera is functional and has a SD card.
• To take a photo, push the photo/video button up. The lights will flash red and
a beep will emit from the remote control to indicate a successful photo.
• To record video, push the photo/video button down. The lights will flash red
to indicate that the video is recording. Push the photo/video button down
again to stop recording.
RESTART
ON
ON
Turn on the remote control and the quadcopter. Push the left control
lever (throttle) to the
highest position, and
then pull it back to the
lowest position.
ON
Hold the left and right
control levers in the lower
right corner position for 2 to
3 seconds. The lights will
flash normally to indicate a
successful restart.
ON
CHARGING THE BATTERY
• Remove the battery from the quadcopter before charging.
• Charge the battery in a dry and ventilated location away from children.
• Let the the battery cool down before charging. Charging a warm battery could cause swelling and
result in a fire hazard. If the battery becomes swollen, replace it immediately.
• Only use the provided USB charging cable.
CHARGE TIME: 1.5 hours | FLIGHT TIME: 6 to 8 minutes
Turn the quadcopter o and
open the battery cover.
Pull the battery wire out of the
power port.
Connect the battery to the USB
charging cable. Make sure that the
ports are securely attached. Plug
the USB charging cable into an
outlet or computer to charge.
Pg. 5
THROW-TO-FLIGHT
The 6 axis gyroscope allows you to throw this drone into flight. Throw the drone and immediately push the
left control lever (throttle) up. The drone will automatically level out and hover.
DRONE BREAKDOWN
Propeller
Propeller
Cage
Reverse
Propeller
Motor
Cover
Motor
Motor
Enclosure
Reverse
Motor
Gear
Light
Cover
Camera
Receiver Board
Battery
Lower
Body
Light
Board
Battery
Cover
Landing Gear
Reverse
Propeller
Propeller
Upper Body
Reverse
Motor
Motor
INSTALLING SPARE PROPELLERS
Make sure that the propellers (A)
and reverse propellers (B) are
attached to the correct locations.
The following is the correct
arrangement:
Pg. 6
(B)
(A)
(B)
(A)
REMOTE CONTROL DIAGRAM
high/low speed
Toggle
Power on/o
360° eversion
Left control lever
(throttle)
Take photo (Up)/
Take video (Down)
Headless Mode (Left)/
Auto Return (Right)
*Hold to the right prior to powering on
the remote to flip roll and turn controls
REMOTE CONTROL DIAGRAM
L/R turn fine tuning
1.
2.
Forward/backward fine tuning
3.
L/R roll fine tuning
4.
Throttle indicator
5.
Forward indicator
6.
Backward indicator
7.
Left indicator
8.
Right indicator
9.
Left roll indicator
10.
Right roll indicator
11.
High/low speed display
12.
Battery level of remote control
13.
Mode 1 indicates normal roll and
turn controls. Mode 2 indicates
flipped roll and turn controls.
Wi-Fi signal strength
14.
Right control lever
ON
Forward/backward
fine tuning
L/R turn fine tuning*
Pg. 7
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Non-responsive drone • Drone battery is depleted
• Remote control battery is depleted
• Frequency on the remote control
does not correspond to the drone
Drone slow to respond
or dicult to maneuver
Drone flies sideways • Gyroscope is not calibrated
One or more propellers
spin in dierent speeds
Propellers don't spin
and lights flashing
• Remote control has insucient power
• Another remote control on the same
frequency is being used nearby
• Gyroscope is not calibrated
• Low battery
• Charge the drone battery
•
Charge/replace the remote control battery
• Adjust the frequency on the remote
control while maintaining the frequency
on the drone
Change/replace the remote control battery
•
• Move out of range of the other remote
control
Re-calibrate the gyroscope by moving both
•
joysticks 45° downward to the right. Hold
both joysticks until the lights of drone flash
Re-calibrate the gyroscope by moving both
•
joysticks 45° downward to the right. Hold
both joysticks until the lights of drone flash
Charge the battery using the USB charger
•
PRODUCT WARRANTY INFORMATION
All items can be returned for any reason within 60 days of the receipt and will receive a full refund as long as the
item is returned in its original product packaging and all accessories from its original shipment are included. All
returned items will receive a full refund back to the original payment method. All returned items will not be charged
a re-stocking fee.
All returned items require an RA (Return Authorization) number, which can only be provided by a Best Choice
Products Customer Service Representative when the return request is submitted. Items received without an RA
may not be accepted or may increase your return processing time. Once an item has been received by Best Choice
Products, refunds or replacements will be processed within 5 business days.
All returns must be shipped back to the Best Choice Products Return Center at the customer’s expense. If the
reason for return is a result of an error by Best Choice Products then Best Choice Products will provide a pre-paid
shipping label via email. Boxes for return shipping will not be provided by Best Choice Products, and is the
customer’s responsibility to either use the original shipping boxes or purchase new boxes.
Pictures may be required for some returns to ensure an item is not damaged prior to its return. Items returned are
not considered undamaged until they are received by Best Choice Products and verified as such. All damages to
items are the customer’s responsibility until the item has been received by and acknowledge by Best Choice
Products as undamaged.
CONTACT US; WE’RE HERE 7 DAYS A WEEK TO HELP YOU!
bestchoiceproducts.com customerservice@
bestchoiceproducts.com
844.948.8400
LEARN MORE!
WARNING
Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage or
loss, whether direct, indirect, or incidental, resulting from the incorrect attachment, improper use,
inadequate maintenance, or neglect of this product.
Loading...