BBS Lighting Area 48 User Manual

AREA 48 SOFT

Linear curve on Indicator Response fast indicator

Strobe on Indicator

SOFTWARE MANUAL

Software vers. 1_3_07

8 8 8 8 8 8

MENU
ENTER
UP
DOWN

Open menu / Go back
Select / Confirm
Scrolling UP / Increase value
Scrolling DOWN / Decrease value

DMX present indicator8 bit Indicator

DMX Channels

Mode Channel Parameter Value Percent Function

8 Bit 1 Dimmer 0 - 255 0 - 100 Coarse dimming

8 Bit 1 Dimmer 0 - 255 0 - 100 Coarse Dimming
w. Strobe 2 Strobe 0 - 5 0 Open
mode 6 - 125 1 - 49 Slow to Fast Strobe
126 - 130 50 Open
131 - 250 51 - 99 Slow to Fast Random
251 - 255 100 Open
3 Strobe 0 0 - 100 Short to Long Flash
length

16 Bit 1 Dimmer 0 - 255 0 - 100 Coarse dimming
2 Dimmer 0 - 255 0 - 100 Fine dimming

16 Bit 1 Dimmer 0 - 255 0 - 100 Coarse dimming
w. Strobe 2 Dimmer 0 - 255 0 - 100 Fine dimming
3 Strobe 0 - 5 0 Open
mode 6 - 125 1 - 49 Slow to Fast Strobe
126 - 130 50 Open
131 - 250 51 - 99 Slow to Fast Random
251 - 255 100 Open
3 Strobe 0 0 - 100 Short to Long Flash
length

Note: Beware, when using Strobe Lenght, that if the Strobe Lenght is egual to or longer than
the flash and interval between flashes, the unit will not strobe.
If maximum strobe length is used the fastest strobe possible will be 17 ( 7% )

WWW.BROTHERS-SONS.DK

SW1

AREA 48 SOFT

USER MANUAL

Software vers. 1_3_07

SOFTWARE MENU

Default values indicated by bold font

At start up the display readout shows e.g.:
Hardware ID: 4572, Product name: Area48, Software version: 1_3_05
When done showing this information, the display shows the set dmx adress.
New:
If no DMX signal is present the unit will at startup enter manual mode, starting at the latest set
manual intensity. This allows for standalone operation.

Addr 1 DMX adress value 1 - 512

Mode Resolution 8 bit resolution

16 bit resolution

Response Slow (fade between values)
Fast (snap between values)

Strobe OFF
On - (adds 2 strobe channels)

Curve Square dimmer curve
Linear dimmer curve

noDMX Action when loss of DMX signal:
HOLD - last received DMX value
OFF - Sets output to zero
MAN - Go to Manual DMX value

Display OFF 2n - Display off after 2 minutes
ON - Display always on

Tools Ver Shows software version

HW Ver Shows hardware version

L Temp LED temperature

P Temp PCB temperature

DMX In 3 first digits shows DMX adress
3 last digits shows DMX value - READOUT ONLY

Reset
Confirm (Reset unit by pressing enter)

- READOUT ONLY

- READOUT ONLY

- READOUT ONLY

- READOUT ONLY

- READOUT ONLY

test display Display test - all seven segments of each digit on

WWW.BROTHERS-SONS.DK

....continues on next page

- READOUT ONLY

SW2