27427 BOSTIK COURT
TEMECULA, CA 92590
For any questions, email us:
tech@bbkperformance.com
INSTALLATION INSTRUCTIONS
INS232
2016 - 2018 CAMARO 6.2L V8
FULL LENGTH HEADERS/
CATTED HEAD PIPES
Part #4044 and 40440
Special Tools required: 10mm, 12mm, 13mm, 15mm
Socket and Wrenches, Pliers, Saw, Welder
!
Install Time: Approximately 4-6 hours.
Diiculty: Average.
INCLUDED IN THIS KIT
(10) 8 x 1.25 x 30mm bolts
(4) M12 x 1.75 x 65mm studs
washers, nuts
(1) 7 inch long heat-wrap
(1) 11 inch long heat-wrap
(5) Zip-ties
(5) Wire-ties
NOTE! AUTOMATIC VERSIONS MUST INSTALL 02 SENSOR EXTENSIONS ON DR-SD ONLY.
MANUAL TRANSMISSION DOES NOT APPLY. WELDING AND CUTTING REQUIRED.
MADE IN U.S.A.
IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.
WWW.BBKPERFORMANCE.COM
UPDATED LAST: April 2018
27427 BOSTIK COURT
TEMECULA, CA 92590
For any questions, email us:
tech@bbkperformance.com
FOLLOW THESE INSTRUCTIONS CAREFULLY TO ENSURE CORRECT FITMENT AND OPERATION
STEP 1
Disconnect the negative battery terminal from the battery located in the truck
on the passenger side. Place a rag over the trunk latch so the trunk lid will not
latch with the battery disconnected.
STEP 2
STEP 3
Remove the engine decorative covers from the engine by simply pulling them
upwards released them from there mounting points.
STEP 4
Disconnect the mass air ow sensor from the air inlet tube. Disconnect the
vacuum tube located next to the mass air ow sensor. Using pliers disconnect
the sound tube from the barb tting located on the top of the air inlet tube.
Loosen the clamp that holds the air inlet tube to the throttle body. Unclip the
sound tube from the side of the air box. Disconnect the inlet tube from the
throttle body and lift up on the air box to release if from its mounting points and
remove it from the vehicle.
MADE IN U.S.A.
IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.
WWW.BBKPERFORMANCE.COM
Remove the (2) Torx bit screws on the driver and passenger side coil covers. On
the driver side remove the oil cap. Disconnect the vacuum tube that goes into
the valve cover on the driver side and passenger side. Once the vacuum tubes
are o lift up on the coil covers and remove them from the vehicle. Replace oil
cap so no debris will enter the engine.
UPDATED LAST: April 2018
Loading...