INS-184
Special Tools
Install Time:
Difficulty:
STEP 1
STEP 3
• Disconnect the Mass Air Flow (MAF) Sensor.
STEP 2
• Loosen the two 10mm mounting bolts that
the stock intake system using pliers.
• Remove the two vent hoses going into the
The clip needs to be pushed back then rotated down
while pulling on the hose to release it from the fitting.
2010-2013 Ford F-150 Raptor SVT 6.2L V8
Cold Air Induction Kit
Part # 1831
Required:
T-20 Torx
•
Follow these instructions carefully to ensure correct fitment and operation.
Approximately
1 Hour
2 out of 5
factory intake sy st e m.
secure the factory intake system to the vehicle.
Also remove the clip on the passenger side of
1
INS-184
STEP 4
STEP 5
STEP 6
• Install the supplied rubber grommet and straight
• Unclip the three clips at the air box and remove
• Remove the MAF Sensor from the stock intake
of the stagger in the hole pattern.
2010-2013 Ford F-150 Raptor SVT 6.2L V8
Cold Air Induction Kit
Part # 1831
the entire system out of the vehicle.
NOTE!!! The rubber coupler also needs to be
removed from the throttle body.
system using a T-20 Torx and install it into the
BBK Cold Air Tube using the supplied
hardware. NOTE!!! The Air Flow of the sensor
needs to be going towards the throttle body,
the sensor should only fit one way because
fitting into the BBK Cold Air Tube.
2
INS-184
STEP 7
STEP 9
• Install the sponge trimming onto the BBK Cold
STEP 10
STEP 8
• Remove the factory vent hose and replace it
into place.
• Place the cold air shield into the vehicle on the
• Install the blue BBK Coupler and BBK Intake
2010-2013 Ford F-150 Raptor SVT 6.2L V8
Cold Air Induction Kit
Part # 1831
Air Intake shield and install the supplied plug
into the BBK Air Filter.
bottom half of the factory air box and use the
three original clamps to secure the shield.
Tube to the throttle body.
with the supplied 3/8” hose. Connect the
supplied 3/8” hose to the plastic straight fitting
on the BBK Intake Tube. The Valve Cover vent
hose with the clip will be connected to the larger
welded tube coming off the BBK Intake Tube.
NOTE!!! Be sure that the clipped vent hose
is pushed onto the welded tube until it clicks
3
INS-184
STEP 11
STEP 12
• Install the supplied Air Filter, plug in the MAF
• Start the vehicle and let idle for a few minutes to
2010-2013 Ford F-150 Raptor SVT 6.2L V8
Cold Air Induction Kit
Part # 1831
ensure that there are no leaks and that the
check engine light doesn’t come on.
Sensor and be sure all the clamps are tight.
4
Loading...