BBK Performance 1724 User Manual

4.0L Jeep Throttle Body
Part # 1724

INS-087

Included in this Kit: BBK throttle body, MAP sensor gasket, throttle body base gasket, T-20 Torx bit, vacuum cap).
Tools Required: 1/4" ratchet, 1/4" socket, 6"extension , 10mm socket.

Step 1 Disconnect negative (–) battery terminal.
Step 2 Remove the intake hose assembly from the vehicle.
Step 3 Unclip the cable attachments from the throttle linkage.
Step 4 Unplug the electrical connections at the IAC, TPS, and MAP sensors.

NOTE

Some models do not use a throttle body mounted MAP sensor. For those vehicles we

supply a vacuum cap to place over the nipple that is installed on the BBK unit.

Step 5 Unbolt and remove the throttle body from the intake manifold.
Step 6 Remove the IAC, TPS, and MAP sensors (if applicable) from the throttle

body using the supplied T-20 Torx bit dropped into a 1/4" socket and install
them onto the BBK throttle body using the supplied IAC gasket. Attach with
the original hardware.

NOTE

When installing the MAP sensor, be sure to make a positive connection between the

rubber hose and vacuum fitting.

Step 7 Mount the BBK throttle body on to the intake manifold using the supplied

base gasket. Attach with the original hardware.

Step 8 Plug in the electrical connections at the IAC, TPS, and MAP sensor.
Step 9 Clip the cable connections onto the linkage of the BBK throttle body.
Step 10 Reconnect negative (–) battery terminal.

Please visit us at WWW.BBKPERFORMANCE.COM to view a fully photographed
installation of this and many other BBK products.

INSTALLATION INSTRUCTIONS

www.BBKPERFORMANCE.com

IMPORTANT—All appropriate safety equipment (e.i., gloves, tools) must be used during the installation of this product(s).
BBK Performance, Inc. accepts no responsibility for injuries resulting in the installation of any product(s).

Disconnect cables

Unplug connectors

Completed installation