B&B Electronics USBPS Datasheet

Document No. USBPS1900 – pg. 1/1
Input Voltage
100-120 VAC
Input Frequency
47-63 Hz
Output Voltage
+15 VDC 3% (at rated input/output)
Ripple Voltage
150 mV or less (at full load)
Withstanding Voltage
3000 VAC between primary and output terminal for 1 min
Efficiency
75%
Hold Up Time
12 ms @ full load, nominal line
Overload Protection
Pulsing mode, auto recovery
Over Voltage Protection
105% - 145%
Inrush Current
Cold start, 20 A maximum
Operating Temperature
0-40C (32-104F) @ 100% load
Operating/Storage Humidity
20-90% relatively humidity
Safety Standards
UL 1950, CSA 22.2, T-mark
Dimensions
2.9 x 1.9 x 1.6 in (74 x 49 x 41 mm)
Plug of DC output
2.1 x 5.5 x 9.5 mm with center “+” & sleeve “-
Length of Output Cable
180 cm (typical)
+15 VDC Wall-Mount Switching Power Supply
Model USBPS
Description
The USBPS is a switching power supply. It is a small, lightweight, wall-mount power supply that provides a regulated output of +15 VDC @ 1.0 A from a 100-120 VAC @ 1.0 A maximum input. The USBPS has a hollow plug with the inside contact as +15 VDC and the outer sleeve as GND. The cord is approximately 6 feet in length.
Compatibility
The USBPS is intended to be used with B&B Electronics Model UISOHUB4, an optically isolated four port USB hub.
Features
Two pole USA plug Compact size, lightweight High reliability, high efficiency High isolation voltage Built-in EMI filter, low ripple noise Short circuit protection Over voltage/over load protection
Specifications
© B&B Electronics -- May 2000
Loading...