Page 1
1. Long press the Mode button to turn
the Party Bar ON/OFF.
2. Long press the LED button to turn
the LED lights On/O. Click press the
LED button to cycle through stored
LED sequences.
3. ACC button turns ON/OFF the
accessory 12v pig tail for an external
LED light bar or other accessory.
4. Click press the Mode button to
toggle between Bluetooth/Aux/USB
listening modes.
5. Press >|| to Pause/Play music.
6. Press Vol +/- to raise and lower the
volume of the Party Bar.
7. Press |<< and >>| buttons to track
forward/reverse on songs.
Unleash the Sound and Illuminate Your Adventure
LED
Mode
(Change Music Mode)
Play/ Pause
Accessory
Volume up
Song reverse
Song forward
Volume down
Detailed instructions can be found at www.bazooka.com
Page 2
Pairing 2 Party Bars together in Bluetooth mode:
1. Disconnect Main Power from the Party Bar being paired.
2. Long press the Pause/Play Button on the Party Bar that
still has power. The voice will say “TWS Pairing”.
3. Reconnect power to the Party Bar being paired and turn
it ON. The Party Bars will nd one another and sync
together. The LED indicator will turn yellow/green when
TWS pairing is successful.
4. Pair your mobile device. (Note: It is very important that
you DO NOT pair your mobile device until AFTER TWS
pairing has been completed or it can interrupt the TWS
pairing process).
5. To remove TWS pairing and return the 2 Party Bars back
to individual pairing mode, long press the Pause/Play
Button on the Master unit.
Loading...