Bazooka MC-HD-AK4 Installation Manual

Harley Davidson Installation Manuel

Preparation

This sheet must be read completely to:

1. Provide assistance/clarification to the installer.

2. Avoid causing injury to installer, customer,
end user, or others.

3. Prevent damage to motorcycle and/or
accessory.

4. Prevent death to customer or other vehicle
operators.

Installer: Please forward this sheet to the
customer after reviewing it.

It is virtually impossible for us to be able to
address every possible situation an installer or
user will encounter. This requires both to
exercise due diligence and to apply some level of
common sense. If you have any question or
problem during the installation, please contact us
as necessary. Read the instructions completely
prior to installation. 90% of questions we receive
could be answered simply by reading the
instructions in their entirety. Phone support will
always provide the quickest response.

Important Information in our instructions will be
provided in the following manner:

SHOP TIP: this is information we have gathered
from hands-on installs or customer feedback.

NOTE: important information regarding the
installation.

CAUTION: failure to follow instructions could
result in damage to motorcycle and/or accessory.

WARNING: failure to follow instructions could
result in injury or death of operator and/or
passenger or others.

NOTE:

1. "Left", "Right", "Front" and "Rear" are
described from the seated position of the bike.

2. Use of owners manual or service manual is
recommended for installation.

3. If so equipped, place the motorcycle on its
center stand on solid, level ground.

CAUTION:

1. Never route wires or install components that
interfere with the operation of the forks,
handlebars, brake/clutch levers or any other
operational function of the motorcycle.

2. When adding electrical accessories, always
disconnect the battery and properly fuse new
electronics.

WARNING:

1. Allow the motorcycle to cool prior to
installation.

2. When operating engine, allow adequate
ventilation.

3. Never route wires or install components that
interfere with the operation of the forks,
handlebars, brake/clutch levers or any other
operational function of the motorcycle.

4. Never allow your accessories to cause
distractions to remove your focus off the bikes
operation. Never forget that this is a high-risk
sport - don't make it a higher risk when you don't
have to.

5. Never allow your accessories to cause
distractions to others on the road.

Harley Davidson Installation Manuel

Preparation

Disassembly of Motorcycle:

1. With motorcycle on its center stand and on solid level
ground, switch off ignition switch and remove seat.

2. Before doing any electrical work to your motorcycle.
It is good practice to disconnect the negative battery
terminal, then the positive terminal. Disconnecting
the terminals in this order will minimize the chance
of sparks and voltage spikes. When reconnecting do

the reverse connect positive then negative terminals.

1. Remove bolts at the bottom of the fairing inside of
the forks. (2 bolts) ( Fig. 1-1 )

Fig 1-1

2. Remove bolts under handgrips on outer fairing.
(2 bolts) ( Fig. 1-2 )

3. Remove bolts in front of firing. Remove outlet bolts.
Leaving center bolt to hold fairing. Remove center
bolt and unplug headlight. (3 bolts) ( Fig. 1-3 )

Fig 1-2

Fig 1-3