Page 1
Label Picture Description QTY
A Left Armrest 1
B Right Armrest 1
C Seat 1
Caution: You must read this before you proceed
Dining Chair
Parts List
Page 1 OF 6
Assembly Instructions
Page 2
D Backrest 1
E Seat Cushion 1
Label Picture Description QTY
①
Bolt (M6*35MM)
9
② Washer 9
③ Allen Key 1
Before Beginning
Assembly:
Hardware
Assembly Preparation
Page 2 OF 6
Page 3
Step 1
Assembly Steps
Overview
This Dining Chair has multiple parts and may require up to 30 minutes to assemble. To
give you an overview of the Dining Chair parts, the above picture is to help you put the
various parts into perspective. Please read through the instructions below to familiarise
yourself with the parts and steps before assembly.
①
②
Page 3 OF 6
If the Dowel does not match the mounting position, please loosen the Dowel by 3-5MM.
Page 4
Step 2
Step 3
Open the carton and place all the parts onto a clean, non-marring surface.
1.1 Insert the Dowel on the Backrest(D) into the mounting position of the Left
Armrest(A).
1.2 Atach Backrest(D) to Left Armrest(A) using Bolts(①) and Washers(②) with Allen
Key(③) as shown in the picture.
Do not fully tighten the Bolts.
Occasionally some of the PE Wicker shifts and covers the mounting positions
preventing easy assembly. The PE Wicker should never be cut, but moved away
from the mounting positions.
2.1 Align Seat(C) with Left Armrest(A) and Backrest(D).
2.2 Attach Seat(C) to Left Armrest(A) and Backrest(D) using Bolts(①) and
Washers(②) with Allen Key(③) as pictured.
Do not fully tighten the Bolts.
①
②
①
②
①
②
Step 3.1
Step 3.2
Page 4 OF 6
Page 5
Step 4
Align Right Armrest(B) to Backrest(D) and Seat(C).
3.1 Insert the Dowel on the Backrest(D) into the mounting position of the Right
Armrest(B).
3.2 Attach Right Armrest(B) to Backrest(D) and Seat(C) using Bolts(①) and
Washers(②) with Allen Key(③) as shown in the picture.
Stand the Chair up.
Exert pressure floorwards, onto the Chair with both your hands.
This pressure will help the Chair reach full alignments status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Bolts and Screws in a sequential
manner, until evenly secured.
When tightening the Bolts and Screws sequentially.
DO NOT tighten any Bolt or Screw fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and Screws and excute the same
above process.
If the Chair is not stable it could lead to damage to the product.
Put the Seat Cushion(E) on the Chair.
Your Dining Chair is ready for use.
This Dining Chair can only be used on the flat, level surface.
Page 5 OF 6
Page 6
Page 6 OF 6
Loading...