Label Picture Description QTY
A Seat Part 1
B Seat Panel 1
C Chair Hind Leg 2
D Chair Front Leg 2
E Seat Cushion 1
F Back Cushion 1
Assembly Instructions
Caution: You must read this before you proceed
Chair
Part List
Page 1 OF 5
Label Picture Description QTY
①
Bolt
(M6x20mm)
17
②
Bolt
(M6x40mm)
6
③ Washer 22
④ Spring Washer 22
⑤ Cap 22
⑥ Allen Key 1
Assembly Preparation
Before
Beginning
Assembly:
×17
×6
×22
×22
×22
×1
Hardware
Page 2 OF 5
Step 2
Place the Seat Part(A) facedown onto a clean, non-marring surface.
Align Seat Part(A) to Seat Panel(B) as shown above.
Attach Seat Part(A) to Seat Panel(B) using Bolts(②), Spring Washers(④) and Washers(③) with Allen Key(⑥).
Do not fully tighten the Bolts.
Assembly Steps
Overview
This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the the
Chair parts, the above picture is to help you put the various parts into perspective. Please read through the
instructions below to familiarise yourself with the parts and steps before assembly.
Step 1
Unpack and place all parts on a clean, non-marring surface.
Seat Part (A)
Seat Panel (B)
Chair Hind Leg (C)
FRONT FACING
Chair Front Leg (D)
Seat Cushion (E)
Back Cushion (F)
Page 3 OF 5
Step 5
Turn over the Chair.
Cover the Bolts(①) and Bolts(②) using Caps(③).
Step 3
Align Seat Panel(B) to Chair Hind Legs(C) and Chair Front Legs(D) as shown above.
Attach Seat Panel(B) to Chair Hind Legs(C) and Chair Front Legs(D) using Bolts(①), Spring Washers(④) and
Washers(③) with Allen Key(⑥).
Do not fully tighten the Bolts.
Step 4
Stand the Chair up.
Exert pressure floorwards, onto the Chair with both your hands.
This pressure will help the Legs and Seat reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly secured.
When tightening the Bolts tighten sequentially.
Do not tighten any Bolt fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and excute the same above process.
Page 4 OF 5
Step 6
Stand the Chair up.
Put the Seat Cushion(E) onto the Chair.
Secure the Seat Cushion using the Velco straps as pictured.
Step 7
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
Page 5 OF 5
Loading...