Page 1
Label Picture Description QTY
A Seat 1
B Chair Legs 1
Assembly Instructions
Caution: You should read this before you proceed
Chair
Picture
Part List
Page 1 OF 5
Page 2
Label Picture Description QTY
①
Bolt
(M6X20mm)
5
② Washer 5
③ Spring Washer 5
④ Cap 5
⑤ Allen Key 1
Before
Beginning
Assembly:
Assembly Preparation
Hardware
Page 2 OF 5
Page 3
Step 2
Place the Seat(A) facedown onto a clean, non-marring surface.
Align the Seat(A) to the Chair Legs(B) as shown above.
Attach the Seat(A) to the Chair Legs(B) using Bolts(①), Spring Washers(②), Washers(③)
and the Allen Key(⑤).
Do not fully tighten the Bolts.
Assembly Steps
Overview
This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an
overview of the the Chair parts, the above picture is to help you put the various parts into
perspective. Please read through the instructions below to familiarise yourself with the parts
and steps before assembly.
Step 1
Unpack and place all parts on a clean, non-marring surface.
Note: The front legs are high and the back ones are low.
FRONT FACING
Seat (A)
Chair Legs (B)
Page 3 OF 5
Page 4
Step 4
Turn over the chair.
Cover the Bolts(①) using Caps(④).
If the Chair is not Stable it could lead to damage of the product.
Exert pressure floorwards, onto the chair with both your hands.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly
secured.
When tightening the Bolts tighten sequentially.
Do not tighten any Bolt fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and excute the same above process.
Step 3
Stand the chair up.
This pressure will help the Legs and chair Top reach full alignment status.
Page 4 OF 5
Page 5
Step 6
Your Chair is ready for use.
This Chair can only be used on a flat and level surface.
Page 5 OF 5
Loading...