Assembly Instructions
For turning the Chair and to prevent damage to the Chair, 02 persons may be needed
Caution: You must read this before you proceed
Chair
CAUTION: This Chair is NOT a TOY.
Keep your child / children at bay during the assembly process of assembly.
to execute this action
1
Parts List
①
②
③ Allen Key 2
③ Allen Key 2
Label Picture Description QTY
A Back Panel 1
B Seat Panel 1
C Left Leg Panel 1
D Right Leg Panel 1
E Leg Support Bar 1
Hardware
Label Picture Description QTY
Screw
(M7x70mm)
Bolt
(M8x55mm)
7
3
2
Assembly Preparation
Before Beginning Assembly:
3
Assembly Steps
Unpack and place all parts on a clean, non-marring surface.
Overview
Back Panel (A)
Left Leg Panel (C)
Leg Support Bar (E)
This Chair has multiple parts and may require up to 30 minutes to assemble. To give
FRONT FACING
Right Leg Panel (D)
Seat Panel (B)
you an overview of the Chair parts, the above picture is to help you put the various
parts into perspective. Please read through the instructions below to familiarise
yourself with the parts and steps before assembly.
Step 1
NOTE: Please arrange and assemble all Parts with same color sticker together
4
Step 2
Step 3
(③).
①
(③).
Place Backrest Panel (A) on a clean, non-marring surface.
Align the tenon on Backrest Panel to the mortise on Left Leg Panel ( C). Then attach
Left Leg Panel (C) to Backrest Panel (A) by using Bolt (②) with Allen Key (③).
Do not fully tighten the Bolts.
Align the tenon on Seat Panel (B) to the mortise on Left Leg Panel (C).
Secure Seat Panel (B) to the Left Leg Panel (C) by using Screws (①) with Allen Key
Do not fully tighten the Screws.
5
Step 4
With assistance from your adult partners, turn the Chair into the other side.
Insert the tenons on Backrest Panel (A), Seat Panel (B) and Leg Support Bar (E) to
the morties on Right Leg Panel (D) as showed in picture above.
Then attach the Right Leg Panel (D) to Backrest Panel (A) by using Bolt (②) with
Allen Key (③).
Do not fully tighten the Bolts.
6
Step 5
Secure the Right Leg Panel (D) to Seat Panel (B) by using Screw (①) with Allen
Screw (①) with Allen Key(③).
Key(③).
Do not fully tighten the Screws.
Step 6
Turn the Chair right side up.
Attach Leg Support Bar (E) to Left Leg Panel (C) and Right Leg Panel (D) by using
Do not fully tighten the Screws.
7
Step 7
Adjust Pre-installed Levellers
height for balance
Inspect the Chair and make sure all parts are adequately connected.
Carefully sit onto the Chair. This pressure will help align all parts at all joints.
In a sequential manner, tighten all Screws and Bolts at all joints.
Adjust the Levellers until the Chair is level with the ground.
To adjust the Levellers, get assistance from an adult partner to lift/lean and
hold the Chair while you are working.
Your Chair is ready for use.
This Chair can only be used on a flat, level surface.
8
9
Loading...