Page 1
Caution: You must read this before you proceed
Rocking Chair
Assembly Instructions
1 of 8
Page 2
Label Picture Description Qty
A Backrest Panel 1
B
Right Leg Panel 1
C
Left Leg Panel 1
D Seat Panel 1
E Footrest Panel 1
F
Front Bar 1
No. Picture Description Qty
① Allen Key 2
② Bolt (M6*40mm) 9
③ Screw (M7*90mm) 5
Hardware
Parts List
2 of 8
Page 3
Assembly Preparation
Before Beginning Assembly:
This Rocking Chair has multiple parts and may require up to some 30 minutes to
assemble. To give you an overview of the Rocking Chair, the above picture is to help
you put the various parts into perspective. Please read through the instructions below
to familiarise yourself with the parts and steps before assembly.
Assembly Steps
Overview
Front Facing
Seat Panel (D)
Backrest
Panel (A)
Right Leg
Panel (B)
Left Leg
Panel (C)
Footrest Panel
(E)
Front Bar (F)
3 of 8
Page 4
Step 1
Unpack and place all parts onto a clean, non-marring surface.
Step 2
Align Footrest Panel(E) to Seat Panel(D) as pictured.
Attach Footrest Panel(E) to Seat Panel(D) using Bolts(②) with Allen Key(①).
Do not fully tighten the Bolts.
②
4 of 8
Page 5
Step 4
Attach Left Leg Panel(C) to Seat Panel(D) using Bolts(②) with Allen Key(①) as
pictured above.
Do not fully tighten the Bolts.
Attach Seat Panel(D) to Right Leg Panel(B) using Bolts(②) with Allen Key(①) as
pictured above.
Do not fully tighten the Bolts.
Step 3
B
5 of 8
Page 6
With assistance from your adult partner, stand the Chair up.
Position Backrest Panel(A) between Left Leg Panel(C) and Right Leg Panel(B) as
pictured above.
5.1) Secure Backrest Panel(A) to Left Leg Panel(C) and Right Leg Panel(B) using
Bolts(②) with Allen Key(①).
Then attach Backrest Panel(A) to Seat Panel(D) using Screws(③) with Allen Key(①).
5.2) Attach Front Bar(F) to Left Leg Panel(C) and Right Leg Panel(B) using
Screws(③) with Allen Key(①).
Inspect it and make sure all parts are adequately connected.
Gently and gracefully, sit into to the Chair.
This will help to align all the parts at all joint areas.
Then get off the Chair and proceed to tighten the Bolts and Screws in a sequential
manner.
When tightening the Bolts and Screws tighten sequentially.
DO NOT tighten any Bolt or Screw fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and execute this same process.
Step 5
F
3
5.1
5.2
B
C
B
C
③
①
6 of 8
Page 7
Step 6
To close the Footrest:
Push the Footrest under the Seat Panel by hand then close the Wooden Lock.
Your Rocking Chair is ready for use.
This Rocking Chair can only be used on a flat, level surface.
Children should always be supervised when using the Rocking Chair.
Step 7
To use the Rocking Chair Footrest:
Open the Wooden Lock.
Pull the Footrest out by hand.
7 of 8
Page 8
8 of 8
Loading...