Label Picture Description QTY
A Table Panel 1
B Frame 2
C Table Bottom 1
D Tempered Glass 1
Assembly Instructions
Caution: You must read this before you proceed
Table
Part List
Page 1 OF 5
Label Picture Description QTY
①
Bolt
(M6x35mm)
9
② Washer 9
③ Allen Key 1
④ Cap 9
⑤ Suction Cup 5
⑥ Spring Washer 9
Hardware
Assembly Preparation
Before
Beginning
Assembly:
×9
×9
×9
×5
×9
×1
Page 2 OF 5
Assembly Steps
Overview
This Table has multiple parts and may require up to 30 minutes to assemble. To give you an
overview of the Table, the above picture is to help you put the various parts into perspective.
Please read through the instructions below to familiarise yourself with the parts and steps
before assembly.
Step 1
Unpack and place all parts on a clean, non-marring surface.
Step 2
Attach Frames(B) to Table Panel(A) using Bolts(①), Spring Washers(⑥) and Washers(②) with
Allen Key(③).
Do not fully tighten the Bolts.
Table Top (A)
Frame (B)
FRONT FACING
Table Bottom (C)
Tempered Glass (D)
Page 3 OF 5
Step 3
Attach Frames(B) to Table Bottom(C) using Bolts(①), Spring Washers(⑥) and Washers(②)
with Allen Key(③).
Fully tighten all Bolts at all joints in a sequential manner.
Step 4
Turn over the Table.
Cover the Bolts(①) using Caps(④).
Step 5
Insert the Suction Cups(⑤) into Table Panel(A) as pictured above.
Page 4 OF 5
Step 6
Carefully place the Tempered Glass(D) on the Table.
Step 7
Adjust the Pre-installed Levelers on the Table Bottom(C) until the Table is level with the ground.
Your Table is ready for use.
This Table can only be used on a flat and level surface.
Page 5 OF 5
Loading...