Bay Isle Home™ BYIL4446 Assembly Instructions

ASSEMBLY INSTRUCTIONS
ASSEMBLY RATING
The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being easy and 5 being difficult). For some products, two persons are recommended.
EASY
DIFFICULT
Page 1 of 5
Allen Wrench
(Included)
Phillips Screwdriver
(Not Included)
Page 2 of 5
MD
Before you begin, please read Page 2 of “Assembly and Care Advice”.
And remember, do not tighten until each step is completed or instructed.
Parts List
#1 x 1 pc Backrest
#2 x 1 pc Left Arm
#3 x 1 pc Right Arm
#4 x 1 pc Bench Cushion
Hardware List
#A x 4 pcs Bolt 1/4”x2-1/2”
#B x 5 pcs Bolt 1/4”x1-3/16”
#C x 10 pcs Screw
#D x 10 pcs Wood Dowel
#5 x 1 pc Rear Support Rail
#6 x 1 pc Front Support Rail
#E x 1 pc
Allen Wrench
Page 3 of 5
Step 1
#D x 10 pcs
Insert two wood dowels (#D) onto the backrest (#1), four wood dowels (#D) onto the rear support rail (#5) and four wood dowels (#D) onto the front support rail (#6).
Step 2
#A x 4 pcs
Enlarged
Note: Right and left is determined by standing in FRONT of the bench in its upright position.
I. Insert the backrest (#1) onto the
left side arm (#2) and secure the bolt (#A) through the left arm (#2) using the Allen wrench (#E) to lock it with the backrest (#1).
II. Insert the front support rail (#6)
onto the left arm and secure the bolt (#A) through the left arm (#2) using the Allen wrench (#E) to lock it with the front support rail (#6).
III. Insert the rear support rail (#5)
onto the left side arm (#2).
IV. Repeat the above process to
assemble the right arm (#3) onto the backrest (#1), the front support rail (#6) and the rear support rail (#5).
Turn right (clockwise) to tighten
Page 4 of 5
Step 3
#4
#B x 5 pcs
#3
I. Align the bench cushion (#4)
onto the assembled parts. Insert 3 bolts (#B) onto the rear support rail (#5) and using an Allen wrench (#E) to lock them down with the bench cushion (#4).
II. Insert a bolt (#B) onto the left
arm (#2) and using an Allen wrench (#E) to lock it down with the bench cushion (#4). Repeat the same for the right arm (#3).
Enlarged
#2
Step 4
#2
#6
#5
Turn right (clockwise) to tighten
I. Insert 6 screws (#C) onto the brackets of the rear support rail (#5)
AND the front support rail (#6) and using a Phillips screwdriver to secure them down with the bench cushion (#4).
II. Insert 2 screws (#C) onto the left arm (#2) and using a Phillips
screwdriver to secure them down with the bench cushion (#4).
III. Repeat process II to secure the right arm (#3) onto the bench cushion
(#4).
#3
Carefully turn the completed table upright. Make sure the table is rested on a flat surface and it does not feel loose or wobbly. If it does, double check that the bolts are secured and properly tighten.
#5
ASSEMBLY IS COMPLETED
Page 5 of 5
Loading...