Caution : You must read this before you proceed
For moving the Table and to prevent damage to the Table,
For moving the Table and to prevent damage to the Table,
TABLE
CAUTION: This Table is NOT a TOY.
Keep your child / children at bay during the assembly
process.
two adults are needed to execute this action.
Page 1 of 6Page 1 of 6
Label Picture Description QTY
Bolt (M6x50mm) 9
1
A Table Top 1
B Leg 4
C Leg Support 4
Label Picture Description QTY
2
3 Washer 9
3
Screw (M6x35mm) 9
4
4 Allen Key 1
Before Beginning Assembly:
Page 2 of 6
OVERVIEW
Table Top (A)
Leg Support (C)
Leg (B)
FRONT FACING
This Table has multiple parts and may require up to 30 minutes to assemble.
To give you an overview of the Table parts, the above picture is to help you
put the various parts into perspective. Please read through the instructions
below to familiarise yourself with the parts and steps before assembly.
Step 1
Unpack and place all parts on a clean, non-marring surface.
Page 3 of 6
Step 2
① ③
④
Do not fully tighten Bolts
C
④
② ④
Do not fully tighten Screws
B
4
1
3
A
Attach Leg(B) to the Table Top(A) using Bolt(①) and Washer(③) with Allen
Key(④).
Repeat the same process with the remaining three Legs(B)
Step 3
Step 3.2
2
B
4
4
2
A
Step 3.1
Place Leg Support(C) between Table Top(A) and Leg(B), as shown above.
3.1) Secure Leg Support(C) to Table Top(A) using Screw(②) with Allen
Key(④)
3.2) Secure Leg Support(C) to Leg(B) using Screw(②) with Allen Key(④)
Repeat the same process with the remaining three Leg Supports(C).
Page 4 of 6
Step 4
secured.
secured.
Inspect Table and make sure all parts are adequately connected.
Turn the Table over, with assistance from your partner.
EXERT pressure, floorwards, onto the Table.
This pressure will help the Legs and Table Top reach alignment at all joints.
Check for wobbles.
In a sequential manner, gradually tighten all Bolts and Screws until evenly
When tightening the Bolts and Screws tighten sequentially.
Do not tighten any Bolt or Screw fully and then move towards the next one.
This could cause the frame to warp.
If there are still wobbles, loosen the Bolts and Screws and execute the
same above process.
If the Table is not Stable it could lead to damage to the product.
Step 5
Your Table is ready for use.
This Table can only be used on a flat, level surface.
Page 5 of 6
Page 6 of 6
Loading...