Bay Isle Home™ BAYI4460 Assembling & Installation Instructions

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJ ON CTEUR.

ASSEMBLING THE FIXTURE (Fig.2, See the Page 2)

1. Shut off the power at the circuit breaker box. Remove old fixture and all
hardware from Junction Box.

2. Carefully unpack your new fixture and lay out all the parts on a clear area.
Take care not to lose any small parts necessary for installation.

3. Thread the two mounting screws about 1/4” into the pre-drilled holes in the
single bar spaced the same distance apart as the holes in the fixture
canopy (A).

4. Install the single bar to the Junction Box with the two Junction Box Screws
as shown. The side of the single bar marked "GND" must face out. The
junction box is not included.

5. Attach the pipe thread(C) to top coupling of the lamp holder(F) and lock it
until tight. Attach the canopy(A) onto the pipe thread(C) and lock it until
tight.

6. Place the candle sleeve (E) onto the lamp holder(F).

7. Install the light bulbs（Not included） in accordance with the fixture
specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!

8. Note: attach the small arm to the side hole of the big ring, aligning the
arm’s screw hole with the ring’s hole, lock it securely with the screws.
The assembled is ring “G”. Attach the bell glass(H) insert to the big
ring(G). While holding the big ring(G) and canopy(A), hanging at both
hooks of the pipe(D).

9. While holding the fixture body assembly towards the ceiling, connect the
electrical wires as Shown in Fig.2, making sure that all wire nuts are
secured. You may have to wrap the connections with electrical tape. If
your outlet has a ground wire (green or bare copper), connect the fixture
ground wire to it. Otherwise connect fixture’s ground wire directly to the
Mounting strap with the green screw provided. Af ter wires are connected,
tuck them carefully inside the Junction Box.

10. Attach the canopy(A) to the Junction box, aligning screws on single bar
with mounting holes in canopy and lock it securely with ball nut (B).

Your installation is now complete. Return power to the junction box and
test the fixture.

FIG.2

(GND)

Thefigureis

FIG.3

ALL RIGHTS RESERVED.

FIXTURE
WIRES
Black or
Smooth

Need assistance with parts or assembly? Please call customer service.

JunctionBox

(Notincluded)

Singlebar

BoxScrew

A

B

C

D

E

F

G

H

onlyfor

reference.

FIXTURE
WIRES
White or
Ribbed

HOUSE
WIRES
Black(Hot)

Thank you for purchasing a product.

HOUSE
WIRES
White
(Neutral)

G

(Screwdriver)
(Notincluded)

FIXTURE
WIRES
Bare
Copper
(Ground)

HOUSE

WIRES

Green or Bare

Copper(Ground)