Baxi Baxi Boston 2 80 OF, Baxi Boston 2 70 OF, Baxi Boston 2 60 OF, Baxi Boston 2 50 OF, Baxi Boston 2 40 OF User Operating Instructions Manual

Please keep these Instructions safe.

Baxi Boston 2 OF

Floor Standing Room Sealed
Gas Fired Central Heating Boilers

Comp N° 235306 - Iss 4 - 7/00

User’s Operating
Instructions

Should you move house, please hand

them over to the next occupier.

OPERATING YOUR BOSTON 2 - Page 2

Natural Gas

Your Baxi Boston 2 is a gas fired, open flued central heating boiler providing
heating for your home and domestic hot water where required.

Baxi Boston 2 80 OF

G.C. No. 41 077 84

Baxi Boston 2 70 OF

G.C. No. 41 077 83

Baxi Boston 2 60 OF

G.C. No. 41 077 82

Baxi Boston 2 50 OF

G.C. No. 41 077 81

Baxi Boston 2 40 OF

G.C. No. 41 077 80

Baxi UK Limited is one of the leading
manufacturers of domestic heating
products in the UK.

Our first priority is to give a high quality
service to our customers. Quality is built
into every Baxi product - products
which fulfil the demands and needs of
customers, offering choice, efficiency
and reliability.

To keep ahead of changing trends, we
have made a commitment to develop
new ideas using the latest technology –
with the aim of continuing to make the
products that customers want to buy.

Baxi is also the largest manufacturing
partnership in the country. Everyone
who works at the company has a
commitment to quality because, as
shareholders, we know that satisfied
customers mean continued success.

We hope you get a satisfactory service
from Baxi. If not, please let us know.

Baxi is a BS-EN ISO 9001
Accredited Company

All CORGI registered installers carry a
CORGI identification card and have a
registration number. Both should be
recorded in your boiler Log Book. You
can check your installer is registered by
telephoning
01256 372300 or writing to:­1 Elmwood,
Chineham Business Park,
Crockford Lane,
Basingstoke. RG24 8WG

1 Remove door panel as shown.
2 Turn the boiler thermostat knob to

the ‘OFF’ position fully anti-clockwise.
3 Turn on the main gas and electricity

supplies to the appliance.
4 To light the pilot: Looking through

the pilot viewing window press the gas
control knob fully inwards and hold.
Press in igniter button and release.
Repeat until pilot ignites. Continue to
hold in gas control knob for
approximately 15 seconds and then
release. Pilot should stay alight.

NOTE: If pilot fails to remain alight or is
extinguished at any time, wait at least 3
minutes then repeat the procedure from
the start of section “4”. Once the pilot is
alight it may be left on permanently.

5 To light the boiler: Ensure that all
external controls, e.g. room thermostat,
timer, etc. are calling for heat. Turn
boiler thermostat fully clockwise to high
setting. Main burner will then light.

The optimum boiler setting depends
upon type of system, external controls
and your requirements. Your installer
will be able to advise you on this
matter.

NOTE: If the pilot light is persistently
extinguished the flue system may be
unsound. Your installer or local gas
region should be contacted as soon as
possible in such circumstances.

“Benchmark” Installation,
Commissioning and Service Record
Log Book

Please ensure that your Installer has
completed the installation and
Commissioning sections of the Log
Book, and hands the Log Book over.
The details of the Log Book will be
required in the event of any warranty
work. Keep the Log Book in a safe
place and ensure that the relevant
sections are completed at each
subsequent regular service visit.