Baumatic SB2, TG2, MG2 User Manual
MG2/SB2/TG2 60cm
Front touch control
ceramic hob
1
User Manual for your Baumatic
MG2/SB2/TG2
60 cm Front touch control 4 hyperspeed
zone ceramic hob.
NOTE: This User Instruction Manual contains important
information, including safety & installation points, which will
enable you to get the most out of your appliance. Please keep it
in a safe place so that it is easily available for future reference; for
you or any person not familiar with the operation of the appliance.
DD 20/12/06
2
Contents
Environmental note 4
Important safety information 5 – 8
Specifications 8 – 9
Ceramic hob surface layout 10
Control panel layout 10
Cooking zone indicators and neon’s 11
Using the ceramic hob 11
Before first use 11
Touch controls 11
Turning the hob on 12
Turning on a zone and setting a power level 12
Turning on the dual circuit zones 12 – 13
Turning off a dual circuit’s outer section 13
Turning off a zone gradually 13
Turning off a zone instantly 14
Turning the hob off 14
Residual heat indicator 14
Locking the hob top 15
Safety cut-off 15
Automatic pre-heating 16
Increasing the power level during automatic pre-heating 17
Switching off automatic pre-heating 17
The hob timer 17 - 18
Hob guidelines 18 - 19
Cleaning and maintenance 20
Cleaning the ceramic hob top 20
After each use 20
Cleaning table 20
Using a ceramic hob scraper 21
Using a specialist ceramic hob cleaner 21
Installation 22
Positioning 22
Unpacking the appliance 22
Installing the appliance 23 – 24
Electrical connection 25
Connecting the mains supply cable 25 – 26
Replacing the mains supply cable 26 - 27
My appliance isn’t working correctly 27 – 28
Baumatic Ltd. Conditions of Guarantee 29
Contact details 30
3
Environmental note
o The packaging materials that Baumatic uses are environmentally
friendly and can be recycled.
o Please discard all packaging material with due regard for the
environment.
4
Important safety information
Your safety is of the utmost importance to Baumatic.
Please make sure that you read this instruction booklet
before attempting to install or use the appliance. If you
are unsure of any of the information contained in this
booklet, please contact the Baumatic Technical
Department.
General Information
o This appliance is designed for domestic household use and for
the cooking and frying of domestic foodstuffs.
o IMPORTANT: The adjacent furniture and all materials used in
the installation must be able to withstand a minimum
temperature of 85°C above the ambient temperature of the
room it is located in, whilst in use.
o Certain types of vinyl or laminate kitchen furniture are
particularly prone to heat damage or discolouration at
temperatures below the guidelines given above.
o Any damage caused by the appliance being installed in
contravention of this temperature limit, will be the liability of
the owner.
o Your new appliance is guaranteed against electrical or
mechanical defects, subject to certain exclusions that are noted
in Baumatic’s Conditions Of Guarantee. The foregoing does not
affect your statutory rights.
o The use of this appliance for any other purpose or in any other
environment without the express agreement of Baumatic Ltd.
will invalidate any warranty or liability claim.
o You should not use this appliance to store items on or as a work
surface.
o No modifications to the appliance are permitted by Baumatic Ltd.
o You should not store or place flammable or highly flammable
liquids/materials on top of or near the appliance. Items made
from aluminium, plastic or plastic film should also be kept away
from the appliance, as they may fuse to the surface.
o Repairs may only be carried out by Baumatic Service
Engineers or their authorised service agent.
5
Child Safety
o Baumatic strongly recommend that babies and young children
are prevented from being near to the appliance and not allowed
to touch the appliance at any time. During and after use, all
surfaces will become hot.
o If it is necessary for younger family members to be in the
kitchen, please ensure that they are kept under close supervision
at all times.
o Older children should only be allowed to utilise the appliance
when supervised.
General Safety
The appliance should only be installed and connected by a
suitable qualified person.
Care should be taken to ensure that the units and work surfaces
that you build the appliance into, meet with the relevant
standards.
If you notice any scratches, splits or cracks in the ceramic glass,
you should immediately switch off the appliance and disconnect
it from your mains supply. Otherwise there is the risk of electric
shock occurring.
During use
Any film or stickers that are present on the hob surface when it
is delivered should be removed before use.
Care should be used when utilizing the appliance, otherwise
there is a risk of burns being caused.
o You should not allow the electrical connection cables to come
into contact with the hob surface when it is hot or any hot
cookware.
o If fat and oil overheats, then it can ignite extremely quickly. For
this reason, when cooking with fat and oil the appliance should
not be left unattended.
Make sure that all of the cooking zones are switched off after
use.
6
Cleaning
o Cleaning of the hob should be carried out on a regular basis.
o IMPORTANT: Before attempting to clean the appliance, it
should be disconnected from the mains and cool.
o Great care should be taken whilst using this appliance and when
following the cleaning procedure.
o You should not use a steam jet or any other high pressure
cleaning equipment to clean the appliance.
Installation
This appliance must be correctly installed by a
suitably qualified person, strictly in accordance
with the manufacturer’s instructions. Please see
the specific section of this booklet that refers to
installation.
o Baumatic Ltd. declines any responsibility for injury or
damage, to person or property, as a result of improper
use or installation of this appliance.
Declaration of conformity
This appliance complies with the following European Directives:
-73/23/EEC dated 19/02/1973 Low Voltage Directive.
-89/336/EEC dated 03/05/1989 EMC Directive inclusive of
Amending Directive 92/31/EEC.
-93/68/EEC dated 22/07/1993 CE Marking Directive.
-89/109/EEC dated 25/01/1992 Materials that can touch food.
o The manufacturer declares that the hob is built using certified
materials and requires the appliance to be installed in
accordance with the standards currently in force. This appliance
must be used by a trained person for domestic purposes only.
To avoid damaging your appliance
o The ceramic glass can be damaged by objects falling onto it.
o The ceramic glass edge can be damaged by knocks from
cookware.
o Cast iron and cast aluminium cookware with damaged bases
may scratch the ceramic surface if they are dragged across it.
7
o Pans should be lifted on and off the hob surface and not
dragged.
o Cooking zones should not be switched on without cookware
placed on it. Also the cookware should not be empty.
Specifications
Product dimensions: Aperture dimensions:
Height: 510 mm Height: 490 mm
Width: 580 mm Width: 560 mm
Depth: 40 mm
Product specifications:
o 1 x 0.75/2.20 kW double hyperspeed zone (diametre 120/210
mm)
o 1 x 1.10/2.00 kW oval hyperspeed zone (diametre 170/265 mm)
o 2 x 1.20 kW hyperspeed zone (diametre 140 mm)
o Front touch control operation
o 4 individual residual heat indicators
o Safety lock
o Timer
o Wrap around designer frame
Standard accessories
o Ceramic hob scraper
8
Electrical details
Rated Voltage: 230 Vac 50 Hz
Supply Connection: 30 A (double pole switched fused
outlet with 3mm contact gap)
Max Rated Inputs: 6.6 kW
Mains Supply Lead: 3 core x 6 mm² (not supplied)
For future reference please record the following information which can
be found on the rating plate and the date of purchase which can be
found on your sales invoice. The rating plate of your hob is located on
the underneath of the appliance. Therefore it is a good idea to record
this information before you install your appliance.
Model Number ……………………………….
Serial Number ……………………………….
Date of Purchase ……………………………….
9
Ceramic hob surface layout
Control panel layout
1. ON/OFF button
2. Safety lock button
3. Safety lock neon
4. Plus button
5. Minus button
6. Cooking zone indicator
7. Decimal point symbol
8. Oval hyperspeed zone dual circuit ON/OFF button
9. Oval hyperspeed zone dual circuit indicator neon
10. Timer plus button
11. Timer minus button
12. Timer display
13. Double hyperspeed zone dual circuit ON/OFF button
14. Double hyperspeed zone dual circuit indicator neon
10
Loading...