NOTE: This User Instruction Manual contains important
information, including safety & installation points, which will
enable you to get the most out of your appliance. Please keep it
in a safe place so that it is easily available for future reference; for
you or any person not familiar with the operation of the appliance.
GS 21/05/12
Contents Page
Environmental note 3
IMPORTANT SAFETY INFORMATION 4 – 6
Specifications of your BWE600GL cooker hood 7
Specifications of your BWE700GL cooker hood 8
Specifications of your BWE900GL cooker hood 9
Using your cooker hood 10 - 11
Before first use 10
To use your cooker hood 10 - 11
Cleaning your cooker hood 11 - 12
The grease filter 12
Maintenance 12 - 15
Removing and cleaning the grease filter 12 - 13
Changing a light bulb 14
Fitting the carbon filters 15
Installation 16 - 25
Electrical connection 16 - 17
Before beginning installation 17 – 18
Attaching the glass canopy 18
Installing your cooker hood 19 - 21
Connecting to external ducting 22
Fitting the chimney 22 – 24
Completing the installation 25
Note: Before discarding an old appliance, switch off and
disconnect it from the power supply. Cut off and render any
plug useless. Cut the cable off directly behind the appliance to
prevent misuse. This should be undertaken by a competent
person.
CONFORMITY TO W.E.E.E. DIRECTIVE
3
IMPORTANT SAFETY INFORMATION
Your safety is of the utmost importance to us. Please
make sure that you read this instruction booklet
before attempting to install or use the appliance. If
you are unsure of any of the information contained in
this booklet, please contact the Advice L
IMPORTANT: Any installation work must be
carried out by a qualified electrician or
competent person.
o The hood must be installed in accordance with the installation
instructions and all measurements followed.
o If the cooker hood is installed for use above a gas appliance then
the provision for ventilation must be in accordance with the Gas
Safety Codes of Practice BS.6172, BS.5440 & BS.6891 (Natural
Gas) and BS.5482 (LP Gas) 1994, the Gas Safety (Installation &
Use) Regulations, the Building Regulations issued by the
Department of the Environment, the Building Standards
(Scotland) (Consolidated) Regulations issued by the Scottish
Development Department.
o It is dangerous to alter the specifications or to modify this
product in any way. Do not tamper with or attempt to modify
the appliance in any way.
o When installing the hood, ensure that the following
recommended distances are observed between the highest point
on the hob top (including the burners) and the bottom of the
cooker hood:
Electric cookers: 700 mm*
Gas cookers: 700 mm*
Coal/ oil cookers: 800 mm
IMPORTANT: DO NOT
SET YOUR COOKER HOOD LESS
THAN 700mm ABOVE YOUR COOKER.
* In the case of a reduced ceiling height, it is possible to reduce the
minimum gap to 400 mm.
ine.
4
o When installed between adjoining wall cabinets, the cabinets
must not overhang the hob.
o The edges of the cooker hood are sharp – be mindful of this as
you handle your appliance, especially during installation and
cleaning. DO NOT CLEAN IN BEHIND THE GREASE FILTER!
o If the room where the cooker hood is to be used contains a fuel
burning appliance such as a central heating boiler then its flue
must be of the sealed or balanced flue type.
o If other types of flue or appliances are fitted, ensure that there is
an adequate supply of air in the room.
o When the hood is being used in extraction mode, ensure that the
ducting is fire retardant and that there are no bends greater than
90 degrees as this will reduce the efficiency of the hood.
o Ensure the ducting for the extractor mode has the same
diameter as the outlet hole all the way through.
o Keep young children from using, playing with
or tampering with the cooker hood. Older
children and infirm persons should be
supervised if they are using the cooker hood.
o Your cooker hood is for domestic use only.
o Please dispose of the packing material carefully – children are
especially vulnerable to it.
o Dirty oil is an even greater fire risk.
o Always put lids on pots and pans when cooking
on a gas cooker.
o The manufacturer refuses to accept any responsibility for
damages arising to the hood or for it catching on fire, from a
5
failure to observe the fire safety advice contained in these
instructions.
o Remember that when in extraction mode, your cooker hood is
removing air from your room. Ensure that proper ventilation
measures are being observed.
o Note that the cooker hood removes odours from your
kitchen, not steam.
o Warning - Always ensure that the cooker
hood has been disconnected from the
power supply before carrying out any work
on the hood, including cleaning and
replacing light bulbs.
o Do not connect the ducting system of this appliance to an
existing ventilation system being used for any other purpose.
o Do not install above a cooker with a high level grill.
o Never leave frying pans unattended during use
as overheated fats and oils might catch fire.
o The cooker hood should not be exposed to a direct heat source
from the cooking device underneath it, i.e. naked flame from a
gas burner or heat from electric hob zones without a pan on
them.
o Do not attempt to use the cooker hood if it is damaged in any
way. Never attempt to use it without the grease filter fitted or if
the filter is excessively greasy!
o Never flambé cook under this cooker hood.
o The lights on this appliance should only be used during operation
of the cooker hood. They should not be left on permanently and
used as a lighting source.
THE MANUFACTURER DECLINES ALL
RESPONSIBILITY IN THE EVENT OF FAILURE TO
OBSERVE THE INSTRUCTIONS GIVEN HERE, FOR
INSTALLATION, MAINTENANCE AND SUITABLE
USE OF THE HOOD.
6
Specifications of your BWE600GL cooker hood
PRODUCT DIMENSIONS:
Height: 600 mm – 950 / 980 mm
Width: 600 mm
Depth: 405 mm
DIMENSIONS OF CHIMNEY SECTION:
297 mm x 265 mm
Your stainless steel cooker hood is fitted with:
o High extraction tangential motor
o Electrical button control operation
o 3 Speeds
o 1 Metallic grease filter
o 2 halogen lights
Extraction capacity:
Noise level min/max:
MODEL NUMBER CARBON FILTER REQUIRED
BWE600GL S1 (1 pair)
500 m³/hr
54 – 58 dB
7
Specifications of your BWE700GL cooker hood
PRODUCT DIMENSIONS:
Height: 600 mm – 950 / 980 mm
Width: 700 mm
Depth: 405 mm
DIMENSIONS OF CHIMNEY SECTION:
297 mm x 265 mm
Your stainless steel cooker hood is fitted with:
o High extraction tangential motor
o Electrical button control operation
o 3 Speeds
o 1 Metallic grease filter
o 2 halogen lights
Extraction capacity:
Noise level min/max:
MODEL NUMBER CARBON FILTER REQUIRED
BWE700GL S1 (1 pair)
500 m³/hr
54 – 58 dB
8
Specifications of your BWE900GL cooker hood
PRODUCT DIMENSIONS:
Height: 600 mm – 950 / 980 mm
Width: 900 mm
Depth: 405 mm
DIMENSIONS OF CHIMNEY SECTION:
297 mm x 265 mm
Your stainless steel cooker hood is fitted with:
o High extraction tangential motor
o Electrical button control operation
o 3 Speeds
o 1 Metallic grease filter
o 2 halogen lights
Extraction capacity:
Noise level min/max: 54 – 58 dB
MODEL NUMBER CARBON FILTER REQUIRED
BWE900GL S1 (1 pair)
500 m³/hr
9
Loading...
+ 19 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.