Baumatic BTC975SS Instruction manual

BTC675SS/BTC975SS
Cooker Hood
my
BTC675SS
60cm Cooker hood
BTC975SS
90 cm Cooker hood
NOTE
information, including safety & installation points, which will
enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference; for you or any person not familiar with the operation of the appliance.
:
This User Instruction Manual contains important
DD 11/04/12
2
Contents Page
Environmental note 4
IMPORTANT SAFETY INFORMATION 5 – 7
Specifications of your cooker hood 8 – 10 BTC675SS 8 - 9 BTC975SS 9 - 10
Using your cooker hood 10
Cleaning your Baumatic cooker hood 11 - 12
The grease filters 11 - 12
Maintenance 12 - 15 Removing and cleaning the grease filter 12 - 13 Changing a light bulb 13 - 14 Fitting the carbon filter 14 - 15
Installation 15 - 25 Electrical connection 16 Before beginning installation 17 Extraction mode or recirculation mode? 18 Installing your cooker hood 18 - 21 Connecting to external ducting 22 Fitting the chimney 22 – 24 Completing the installation 25
Troubleshooting 25 – 26
Baumatic consumables 27
Contact details 28
3
ENVIRONMENTAL NOTE
Note: Before discarding an old appliance, switch off and disconnect it from the power supply. Cut off and render any plug useless. Cut the cable off directly behind the appliance to prevent misuse. This should be undertaken by a competent person.
CONFORMITY TO W.E.E.E. DIRECTIVE
4
IMPORTANT SAFETY INFORMATION
Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Baumatic Advice Line.
IMPORTANT: Any installation work must be carried out by a qualified electrician or competent person.
o The hood must be installed in accordance with the installation
instructions and all measurements followed.
o If the cooker hood is installed for use above a gas appliance then
the provision for ventilation must be in accordance with the Gas Safety Codes of Practice BS.6172, BS.5440 & BS.6891 (Natural Gas) and BS.5482 (LP Gas) 1994, the Gas Safety (Installation & Use) Regulations, the Building Regulations issued by the Department of the Environment, the Building Standards (Scotland) (Consolidated) Regulations issued by the Scottish Development Department.
o It is dangerous to alter the specifications or to modify this
product. Do not tamper with it or attempt to modify the appliance in any way.
o When installing the hood, ensure that the following
recommended distances are observed between the highest point on the hob top (including the burners) and the bottom of the cooker hood:
Electric cookers: 700 mm Gas cookers: 700 mm Coal/ oil cookers: 800 mm
IMPORTANT: DO NOT SET YOUR COOKER HOOD LESS THAN 700mm ABOVE YOUR COOKER.
o When installed between adjoining wall cabinets, the cabinets
must not overhang the hob.
5
o The edges of the cooker hood are sharp – be mindful of this as
you handle your appliance, especially during installation and cleaning. DO NOT CLEAN IN BEHIND THE GREASE FILTERS!
o If the room where the cooker hood is to be used contains a fuel
burning appliance such as a central heating boiler then its flue must be of the sealed or balanced flue type.
o If other types of flue or appliances are fitted, ensure that there is
an adequate supply of air in the room.
o When the hood is being used in its extractor function, ensure
that the ducting is fire retardant and that there are no bends sharper than 90 degrees as this will reduce the efficiency of the hood.
o Ensure the ducting for the extractor function has the same
diameter as the outlet hole all the way through.
o Keep young children from using, playing with
or tampering with the cooker hood. Older children and infirm persons should be supervised if they are using the cooker hood.
o Your cooker hood is for domestic use only.
o Please dispose of the packing material carefully – children are
especially vulnerable to it.
o Dirty oil is an even greater fire risk.
o Always put lids on pots and pans when cooking
on a gas cooker.
o The manufacturer refuses to accept any responsibility for
damages arising to the hood or it catching on fire, from a failure to observe the fire safety advice contained in this instruction booklet.
6
o Remember that when in extraction mode, your cooker hood is
removing air from your room. Ensure that proper ventilation measures are being observed.
o Note: Your cooker hood is designed to remove cooking
odours from the room and not steam.
o Warning - Always ensure that the cooker
hood has been disconnected from the power supply before carrying out any work on the hood, including replacing light bulbs.
o Do not connect the ducting system of this appliance to any
existing ventilation system which is being used for any other purpose.
o Do not install above a cooker with a high level grill.
o Never leave frying pans unattended during use
as overheated fats and oils might catch fire.
o The lights on this appliance should only be used during operation
of the cooker hood. They should not be left on permanently and used as a lighting source.
o The cooker hood should not be exposed to a direct heat source
from the cooking device underneath it, i.e. a naked flame from a gas burner or heat from electric hob zones without a pan on them.
o Do not attempt to use the cooker hood if it is damaged in any
way. Never attempt to use it without the grease filters fitted or if the filters are excessively greasy!
o Never flambé cook under this cooker hood.
THE MANUFACTURER DECLINES ALL RESPONSIBILITY IN THE EVENT OF FAILURE TO OBSERVE THE INSTRUCTIONS GIVEN HERE, FOR INSTALLATION, MAINTENANCE AND SUITABLE USE OF THE HOOD.
7
Specifications of your cooker hood
BTC675SS
PRODUCT DIMENSIONS
Height: 540 - 920 mm* Width: 600 mm Depth: 490 mm
DIMENSIONS OF CHIMNEY SECTION:
Width: 303 mm Depth: 276 mm
* IMPORTANT: Please see the installation instructions to obtain precise information on the height requirements for this product.
Your cooker hood is fitted with:
o Electronic pushbutton control operation o 3 Speeds o 1 x Metallic grease filter o 2 x Halogen lights
8
o Extraction capacity: 750 m³/hr o Optional extras: 1 x pair S1 Carbon filters required for
recirculation
BTC975SS
PRODUCT DIMENSIONS
Height: 540 - 920 mm* Width: 900 mm Depth: 490 mm
DIMENSIONS OF CHIMNEY SECTION:
Width: 303 mm Depth: 276 mm
* IMPORTANT: Please see the installation instructions to obtain precise information on the height requirements for this product.
Your cooker hood is fitted with:
o Electronic pushbutton control operation o 3 Speeds o 3 x Metallic grease filter o 2 x Halogen lights
9
o Extraction capacity: 750 m³/hr o Optional extras: 1 x pair S1 Carbon filters required for
recirculation
* If you are using the appliance in recirculation mode, then PLEASE NOTE that some of the vent in the upper chimney section must be exposed. You will have to take this into account when calculating the minimum height of the cooker hood when installed.
Using your cooker hood
o Make sure that it has been installed by a suitably qualified
person, as per the information contained in Baumatic’s installation instructions.
o Find the control panel, which is located on the right hand side of
the canopy.
o There are several buttons on the control panel, which perform
separate functions.
= Low speed
= Medium speed
= High speed
= Light ON/OFF button
IMPORTANT: IDEALLY YOU SHOULD TURN ON YOUR HOOD TEN MINUTES BEFORE YOU START TO COOK, OR AT THE VERY LEAST WHEN YOU BEGIN COOKING. YOU SHOULD ALSO RUN YOUR HOOD FOR TEN MINUTES AFTER YOU HAVE FINISHED COOKING.
10
Loading...
+ 22 hidden pages