1
BIZ2SS 30 cm induction zone
hob
BF23SS 2 induction & 2 hyperspeed
zone ceramic hob
BF24SS 4 induction zone ceramic
hob
LIB30121
INDUCTION HOBS
BIZ2SS-BF23SS-BF24SS
DD 15/01/07
RATING PLATE
The appliance rating plate is located on the underside of the hob, once the appliance is
fitted into its housing then the rating plate is no longer visible. For future reference
please write the rating plate information in the box below.
Model Number ……………………………….
Serial Number ……………………………….
Date of Purchase ……………………………….
Supplier ……………………………….
1
! Important safety notes.
We have included this safety information for the purpose of your safety. Please read this information carefully before
installing your hob. Should you be unsure of any of these notes please contact the Baumatic Ltd Technical department.
Baumatic Ltd Technical department Tel: 0118 933 6933
Installation
¾ It is important that this appliance is installed by a qualified / competent person, such as one holding NICEIC
registration and that the appliance is installed in accordance with the latest edition of the IEE WIRING
regulations and the manufactures installation instructions. Before connecting the appliance to the electricity
supply, make sure that the supply voltage on the rating plate corresponds with the mains supply voltage.
¾ Do not install the appliance if the ceramic glass top is damaged in any way.
¾ Do not modify the appliance in any way, this will void your warranty and possibly render the appliance
dangerous.
¾ Ensure that all packaging is removed before installing or using the appliance.
Use of the hob
¾ Do not use the appliance until the installation is complete.
¾ Ensure that the appliance is switched OFF when not in use.
¾ Never leave the hob unattended when in use, particularly when cooking with oil and fat.
¾ Always use pans that are suited to the heating zone being used, and are the correct size for the zone, never uses
pans that are unstable or defective in any way, the pans must be suitable for INDUCTION HEATING.
¾ Never use plastic or aluminium foil dishes on the appliance.
¾ This appliance has been manufactured for domestic use only and is therefore not suitable for use in a
commercial or industrial environment.
¾ Only turn the cooking zones ON when a saucepan is on the cooking zone.
¾ Never store flammable materials such as aerosols and detergents in draws or cupboards under the hob.
¾ Do not drop saucepans or cooking utensils onto the ceramic cooking surface.
¾ Never use the ceramic cooking surface as a storage or worktop area.
¾ Do not use the appliance if the ceramic surface is accidentally damaged, call the Baumatic service department,
as the ceramic glass will need to be replaced.
¾ Only clean the hob in accordance with the cleaning and maintenance instructions.
¾ Never allow sugar or acidic foodstuffs to be spilled onto the ceramic cooking surface as it eats into the glass
and is impossible to remove.
¾ Do not use the appliance as a space heater or to dry clothes.
¾ Do not install this appliance next to soft furnishings or curtains.
Child Care
¾ Never allow children to play near or with the appliance. This appliance is designed to be used by adults.
¾ The hob gets hot when in use and children should be kept well during use.
¾ Cooking pots and pans should be kept out of reach of children when in use to avoid injury.
Servicing
¾ This appliance should only be repaired or serviced by a Baumatic Ltd Technician or one of there authorised
service agents
Environment
¾ Please dispose of all waste packing materials and old appliances at an authorised disposal site giving due
regard for the environment. (Advice on such issues is available from your local authority).
2
General Information
Please read this booklet thoroughly before you use this appliance. It is important that you
understand all the control functions before commencing to cook with your Baumatic appliance. The information and
warnings contained in this booklet are designed to assist you in obtaining the best use of your new Baumatic appliance.
This appliance complies with all current European safety legislation, however Baumatic Ltd wish to emphasise that
compliance does not remove the fact that surfaces will become hot during use and retain heat after operation.
Baumatic Ltd declines any responsibility for injury or damage to persons or property as a result of improper use
or installation of this appliance.
Heat, steam and moisture will be created during use, take care to avoid injury and ensure that the room is
adequately ventilated. If prolonged use occurs, additional ventilation may be required. Please consult your
Qualified Installer if you are in any doubt about the amount required.
NOTE: The housing, adjacent furniture and all materials used in the installation must be able to withstand a minimum
temperature rise of 85°C above ambient during periods of operation. This information is for guidance only and the
actual withstand temperature will depend on the
performance rating for the surface finish of the worktop. Certain types of kitchen furniture surface finishes are
particularly prone to heat damage or discoloration at temperatures lower than the above guidelines. Installing the
appliance in contravention of the guidance given will be at the liability of the owner. The use for any other purpose or in
any other environment without the express agreement of Baumatic Ltd, would invalidate any warrantee or liability
claim.
Your new appliance is guaranteed against electrical or mechanical defects subject to certain
exclusions noted in Baumatic Ltd Conditions of Guarantee.
The aforegoing does not affect your statutory rights. The Warrantee applies to Great Britain and Northern Ireland only.
In the event that you require any After Sales Service or repairs, please contact the Baumatic
Service Department on telephone number – 0118 933 6911.
When first used, an odor may be emitted by any residual protective finish or moisture, which
will cease after a short period of time.
This appliance has been constructed and distributed in compliance with the essential requirements of the following EEC
DIRECTIVES and EUROPEAN NORMS:
CE Marking – 93/68 Low Voltage – 73/23 EMC – 89/336
Materials that can touch food – 89/109.
Safety Standards – EN 60 335-1, EN 60 335 – 2 – 6.
This appliance is marked according to the European directive 20002/96/EC on waste Electrical and electronic
Equipment (WEEE). This guideline is the frame of a europeanwide validity of return and recycling on Waste
electrical and electronic Equipment
As Baumatic have a policy of continued product improvement, the right is reserved to adjust and make any
modifications deemed necessary without notification.
NOTE: This ceramic Induction Hob fully complies with current legislation regarding electro-magnetic
interference and is designed not to interfere with other electronic appliances providing these comply with the
same legislation.
As the hob generates magnetic fields in its immediate vicinity, Pacemakers and Active Heart Implants must be
designed to comply with relevant regulations. If in doubt, you should consult the manufacturer of your device or
your Doctor.
In this respect, Baumatic can only guarantee the conformity of our own product.
3
INSTALLATION INSTRUCTIONS
TECHNICAL DATA
MODELS BIZ2SS BF23SS BF24SS
Voltage 230V 230V 230V
Current 16 29 32
Hi-light plate 1800 W - 1 Hi-light plate 1200W - 1 Induction plate 2200W /Booster 3000W 1 1 1
Induction plate 18000W - - 1
Induction plate 18000W/Booster 2800W - - 1
Induction plate 1400W 1 1 1
Max power W 3.6kW 6.6kW 7.2kW
Electrical cable 3x2,5 mm2 3x2,5 mm2 3x2,5 mm2
1.Installation (Fig 1)
Installation is the buyer’s responsibility. The manufacturer accepts no liability for this service. Any action that
the manufacturer has to take due to an erroneous installation will not be covered by the guarantee.
The flush-mounted cook tops are designed for installation in work tops made of all kinds of material,
providing they can withstand a temperature of 100°C, and are between 25 and 40 mm thick. If the cook top is
installed in a position so that the side of a kitchen unit comes up against its left-hand or right-hand side, the
distance between the vertical panel and the edge of the cook top must always be at least 150 mm. The
distance between the back wall and the edge of the cook top must be at least 55 mm. A partition made of
insulating material (wood or the like) must be inserted between the cook top and the space below. This
partition must be at least 25 mm from the underside of the cook top tray.
Fixing the cook top to the unit (Fig 2)
The cook top is fixed to the unit by means of the brackets and accessories provided. Holes are provided in
the bottom of the tray where the tabs (A) are inserted so that you can attach the screws (C) that hold the
brackets (B) in place.
Applying the seal (Fig 3)
Important - The figure shows how the seal must be attached all around the perimeter.
This cook top has been designed for non-professional, domestic use.
2.Electric connections (Fig 4)
Check the details given on the nameplate situated on the underside of the cook top, then make sure that the
rated mains voltage and power available are suitable for its operation.
Before making the electric connections, check the efficiency of the earthing system. Earthing of the cook top
is compulsory by law. The manufacturer will accept no liability for any personal injury or damage to property
deriving from failure to comply with this requirement.
For models without a plug, fit a standard plug capable of withstanding the specified load on the power cord.
The cord’s earthing conductor is colored yellow and green. The plug must be accessible.
If you prefer to make a fixed connection to the mains, insert an all-pole circuit breaker with a breaking gap of
at least 3 mm between the cook top and the mains.
To connect the cook top power cord, loosen and remove the cover on the terminal block in order to access
the contacts inside. Make the connection, blocking the cord in place with the cable clamp provided and then
close the terminal block cover again immediately.
If you have to change the cord, the earthing (yellow / green) conductor must always be 10 mm longer than
the line conductors.
Use only rubber cable type H05RR-F.
DECLARATION OF CONFORMITY. In the parts destined to come into contact with foodstuffs, this appliance
is in accordance with the requirements of the EC directive 89/109 transposed in the Italian Legislative
Decree N° 108 of 25/01/92.
CE Appliance conforming to the European directives 89/336/EEC, 93/68/EEC, 73/23/EEC and subsequent
revisions.
4
Loading...