Baumatic BE600GL, BE700GL, BE900GL Instruction manual
BE600GL/BE700GL/
BE900GL
Cooker Hood
User Manual for your Baumatic
BE600GL Cooker Hood
60 cm Glass cooker hood in stainless steel
BE700GL Cooker Hood
70 cm Glass cooker hood in stainless steel
BE900GL Cooker Hood
90 cm Glass cooker hood in stainless steel
NOTE: This User Instruction Manual contains important
information, including safety & installation points, which will
enable you to get the most out of your appliance. Please keep it
in a safe place so that it is easily available for future reference; for
you or any person not familiar with the operation of the appliance.
GS 24/07/13
2
Contents Page
Environmental note 4
IMPORTANT SAFETY INFORMATION 5 – 7
Specifications of your BE600GL cooker hood 8
Specifications of your BE700GL cooker hood 9
Specifications of your BE900GL cooker hood 10
Using your cooker hood 11 - 12
Before first use 11
To use your cooker hood 11 - 12
Cleaning your cooker hood 12 - 13
The grease filter 13
Maintenance 13 - 16
Removing and cleaning the grease filter 13 - 14
Changing a light bulb 15
Fitting the carbon filters 16
Installation 17 - 26
Electrical connection 17 - 18
Before beginning installation 18 - 19
Attaching the glass canopy 19
Installing your cooker hood 20 - 22
Connecting to external ducting 23
Fitting the chimney 23 – 25
Completing the installation 26
Extraction mode or recirculation mode? 26
Troubleshooting 27 – 28
Baumatic consumables 29
Contact details 31
3
ENVIRONMENTAL NOTE
Note: Before discarding an old appliance, switch off and
disconnect it from the power supply. Cut off and render any
plug useless. Cut the cable off directly behind the appliance to
prevent misuse. This should be undertaken by a competent
person.
CONFORMITY TO W.E.E.E. DIRECTIVE
4
IMPORTANT SAFETY INFORMATION
Your safety is of the utmost importance to Baumatic.
Please make sure that you read this instruction booklet
before attempting to install or use the appliance. If you
are unsure of any of the information contained in this
booklet, please contact the Baumatic Advice Line.
IMPORTANT: Any installation work must be carried
out by a qualified electrician or competent person.
o The hood must be installed in accordance with the installation
instructions and all measurements followed.
o If the cooker hood is installed for use above a gas appliance then
the provision for ventilation must be in accordance with the Gas
Safety Codes of Practice BS.6172, BS.5440 & BS.6891 (Natural
Gas) and BS.5482 (LP Gas) 1994, the Gas Safety (Installation &
Use) Regulations, the Building Regulations issued by the
Department of the Environment, the Building Standards
(Scotland) (Consolidated) Regulations issued by the Scottish
Development Department.
o It is dangerous to alter the specifications or to modify this
product. Do not tamper with it or attempt to modify the
appliance in any way.
o When installing the hood, ensure that the following
recommended distances are observed between the highest point
on the hob top (including the burners) and the bottom of the
cooker hood:
Electric cookers: 700 mm*
Gas cookers: 700 mm*
Coal/ oil cookers: 800 mm
IMPORTANT: DO NOT SET YOUR COOKER HOOD LESS
THAN 700mm ABOVE YOUR COOKER.
* In the case of a reduced ceiling height where the above distances
are not achievable, it is possible to reduce the clearance to an absolute
minimum of 400mm from the highest point of the hob top below.
IMPORTANT: DO NOT SET YOUR COOKER HOOD LESS THAN
400MM ABOVE THE HIGHEST POINT ON THE HOB TOP BELOW.
5
o When installed between adjoining wall cabinets, the cabinets
must not overhang the hob.
o The edges of the cooker hood are sharp – be mindful of this as
you handle your appliance, especially during installation and
cleaning. DO NOT CLEAN IN BEHIND THE GREASE FILTERS!
o If the room where the cooker hood is to be used contains a fuel
burning appliance such as a central heating boiler then its flue
must be of the sealed or balanced flue type.
o If other types of flue or appliances are fitted, ensure that there is
an adequate supply of air in the room.
o When the hood is being used in its extractor function, ensure
that the ducting is fire retardant and that there are no bends
sharper than 90 degrees as this will reduce the efficiency of the
hood.
o Ensure the ducting for the extractor function has the same
diameter as the outlet hole all the way through.
o Keep young children from using, playing with or
tampering with the cooker hood. Older children
and infirm persons should be supervised if they are
using the cooker hood.
o Your cooker hood is for domestic use only.
o Please dispose of the packing material carefully – children are
especially vulnerable to it.
o Dirty oil is an even greater fire risk.
o Always put lids on pots and pans when cooking
on a gas cooker.
o The manufacturer refuses to accept any responsibility for
damages arising to the hood or it catching on fire, from a failure
to observe the fire safety advice contained in this instruction
booklet.
6
o Remember that when in extraction mode, your cooker hood is
removing air from your room. Ensure that proper ventilation
measures are being observed.
o Note that it removes odours from your room, not steam.
o Warning - Always ensure that the cooker
hood has been disconnected from the
power supply before carrying out any work
on the hood, including replacing light bulbs.
o Do not connect the ducting system of this appliance to any
existing ventilation system which is being used for any other
purpose.
o Do not install above a cooker with a high level grill.
o Never leave frying pans unattended during use
as overheated fats and oils might catch fire.
o The lights on this appliance should only be used
during operation of the cooker hood. They should not be left on
permanently and used as a lighting source.
o The cooker hood should not be exposed to a direct heat source
from the cooking device underneath it, i.e. naked flame from a
gas burner or heat from electric hob zones without a pan on
them.
o Do not attempt to use the cooker hood if it is damaged in any
way. Never attempt to use it without the grease filters fitted or
if the filters are excessively greasy!
o Never flambé cook under this cooker hood.
THE MANUFACTURER DECLINES ALL
RESPONSIBILITY IN THE EVENT OF FAILURE TO
OBSERVE THE INSTRUCTIONS GIVEN HERE, FOR
INSTALLATION, MAINTENANCE AND SUITABLE
USE OF THE HOOD.
7
Specifications of your BE600GL cooker hood
PRODUCT DIMENSIONS:
Height: 600 mm – 980 mm
Width: 600 mm
Depth: 405 mm
DIMENSIONS OF CHIMNEY SECTION:
297 mm x 265 mm
Your stainless steel cooker hood is fitted with:
o Integrated axial motor
o Electronic push button control operation
o 3 Speeds
o 1 Washable aluminium grease filter
o 2 Halogen lights
o Perimeter extraction
Extraction capacity:
Noise level min/max: 61 / 65 / 68 dB
MODEL NUMBER CARBON FILTER REQUIRED
BE600GL S1 (1 pair)
750 m³/hr
8
Specifications of your BE700GL cooker hood
PRODUCT DIMENSIONS:
Height: 600 mm – 950 mm
Width: 700 mm
Depth: 405 mm
DIMENSIONS OF CHIMNEY SECTION:
297 mm x 265 mm
Your stainless steel cooker hood is fitted with:
o Integrated axial motor
o Electronic push button control operation
o 3 Speeds
o 1 Washable aluminium grease filter
o 2 Halogen lights
o Perimeter extraction
Extraction capacity:
Noise level min/max: 61 / 65 / 68 dB
MODEL NUMBER CARBON FILTER REQUIRED
BE700GL S1 (1 pair)
750 m³/hr
9
Specifications of your BE900GL cooker hood
PRODUCT DIMENSIONS:
Height: 600 mm – 980 mm
Width: 900 mm
Depth: 405 mm
DIMENSIONS OF CHIMNEY SECTION:
297 mm x 265 mm
Your stainless steel cooker hood is fitted with:
o Integrated axial motor
o Electronic push button control operation
o 3 Speeds
o 1 Washable aluminium grease filter
o 2 Halogen lights
Extraction capacity:
Noise level min/max: 61 / 65/ 68 dB
MODEL NUMBER CARBON FILTER REQUIRED
BE900GL S1 (1 pair)
750 m³/hr
10
Loading...