MANUAL FOR THE USE AND INSTALLATION OF YOUR DISHWASER
9
10
8
11
12
14
17
13
16
15
FOR BETTER AND EASIER UNDERSTANDING
OF THIS MANUAL AND DISHWASHER FUNCTIONS
KEEP THIS PAGE OPEN
AND IT WILL THEN BE EASIER TO FOLLOW.
.
On/off pilot light.
Start/stop button.
Other function buttons.
Rinse aid level indicator.
Salt level indicator.
Door handle.
Wash-stage visualisor.
Salt level regulator.
Upper basket.
Upper distributor.
Lower distributor.
Filter.
Salt dispenser.
Detergent tray.
Rinse aid tray.
Rinse aid indicator.
Salt indicator.
CONTENTS
Water hardness: ...............................................................27
Wash products:......................................................28-29-30
How to place your crockery correctly:...............31-32-33
Important advice: ............................................................34
Starting the dishwasher: .................................................35
Programme selection: .....................................................35
Wash programme selection:.....................................36-37
How to solve problems:.............................................38-39
Page
Here I am,
to save you from
the washing-up.
"Hello! I am your dishwasher. But
before I start some friendly advice."
CAUTION IN HARD WATER AREAS!
The water from your tap at home is in perfect condition but be careful, it contains lime,
and if we don't keep it under control it could have some harmful effects.
Before beginning, it is essential to find out about the water hardness of your area, that is,
the amount of lime in the water. The Water Company in your area or your Town Council
will give you this information.
But don't worry, in order to prevent any harmful effects from Lime, my water softening
device will always ensure perfect functioning..
ADJUSTING THE AMOUNT OF SALT
This 4-position regulator can be
found on the right hand side of the
dishwasher . Use a coin to select
the right position.
You can then select the right position on the salt regulator. The following table shows y ou
the correct positions.
O-13 HF (0-7 DH) 14-38 HF (8-21 DH) 39-50 HF (22-28 DH) 51-63 HF (29-35 DH) MORE 63 HF (36 DH)LIME LEVEL
RESULT OF
THE TEST
HF Water hardness given in French degrees.
DH Water hardness given in German degrees.
These simple adjustments will ensur e correct dishwasher function and are important.
27
NO SALT
REQUIRED
Positión
1 Positión 2 Positión 3 Positión 4
DISHWASHING PRODUCTS
To ensure I am always in peak working condition I
too need my own specific washing products. They are:
1. SALT
2. DETERGENT
3. RINSE AID
ENGLISH
1. SALT.
I was fitted with a Water Softener
it clean for dishwashing; for my Water Softener to work you have to put salt in the salt
container. But remember, only if the water hardness requires it.
Remember! Make sure not to use cooking salt, use only special salt for dishwashers
available in all supermarkets.
Where and how is the salt added first time use?
•
So that lime does not cause any harmful effects.
, which takes the lime out of your water and leaves
First you must take out my lower rack. Unscrew the
dispenser cap and take it off .
- Use the funnel provided with the dishwasher to fill the dispenser full of salt (about 1,5
Kg) and then fill with water.
- Always use a spoon to mix it properly.
Important: This operation must be carried out only before the first
wash. Later you only need to top up the salt level.
- Once you have finished filling up with salt and water, make sure
you screw the cap back on securely and that no traces of salt are
left on the bottom of the dishwasher which could leave salt deposits.
28
When do I need more salt?
•
Don't worry about it. The indicator on your dishwasher will tell you.
Models with Optical Indicator: This is located
•
in the cap of my salt dispenser .
The indicator is a green float which in its highest
position indicates that I do not need salt. Conversely,
if the float has fallen and, therefore the green colour
is not visible, this means that you must add more
salt.
Models with Luminous Indicator: in the control panel. When the light comes
•
on, fill the dispenser with salt.
As we have seen in the sections above, it is possible that the water hardness in your area does
not require you to add salt; in that case do not worry if you see the luminous indicator lit.
It is important to remember that you should always fill the salt dispenser before
using the dishwasher, never afterwards.
2.DETERGENT. The type of program will give you the quantity required.
But lets get to wor k. First, fill me up with detergent. Do you see the detergent compartment
which is built into the inner door . That is where you put the detergent.
How much detergent do I need?
•
For a non-concentrated detergent in powder
or tablet form;
- For a pre-washed - none.
- For a delicate, economic or rapid wash; 1 measure
of 25 gr. (one and a half level soup spoonfuls or one tablet)
- For a normal or intensive wash,2 measures,1 of 25 gr. in the
dispenser (or one tablet) and another of 5 gr or 15 gr.
(a level soup spoonful or half a tablet) in the inner door.
For concentrated and liquid detergent follo w the deter gent man ufactur ers recommendations.
29
3. RINSE AID.
Cleans and adds brilliance.
The principal function of this product is to facilitate drying and prevent water drops
being left on the dishes after the wash, while at the same time giving all surfaces a
brilliant shine.
Where and how is rinse aid added?
•
I have a compartment in the upper part of the inner door , just to the right of the
detergent compartment.
ENGLISH
Turn and take off the cap of this compartment, and add rinse aid up to the indicated
maximum. Be careful that it does not over flow; if this occurs dry the spilt drops with a
cloth so that the wash quality will be correct otherwise over foaming may occur.
How is the rinse aid intake regulated?
•
Once you have filled the compartment, you can adjust the level of rinse aid released by
moving the selector in the dispenser between numbers 1 to 6 (it leaves the factory in
position no. 2).
Before adjustment, I recommend that y ou judge for yourself b y observing the final result
of each wash. If there are water drops or lime stains on the dishes, adjust the selector
to a higher number, conversely adjust to a lower number to reduce the quantity released
if the dishes show white, sticky streaks.
When do you have to add rinse aid?
•
Only when it is indicated on your particular dishwasher model.
Models with Transparent-Window Indicator: This is beside the rinse aid compartment.
•
If it is clear it needs rinse aid; fill it taking care that it does not overflow. If it is dark it has
sufficient.
Models with Luminous Indicator: When the liquid runs out, this light on the
•
control panel comes on. This is a clear warning to refill with rinse aid.
30
Loading...