BDW10
USER AND INSTALLATION
INSTRUCTIONS
1
GB
BEFORE USING THE APPLIANCE
1
Norms and regulations to be respected
• The dishwasher may only be used to clean household dishes. If the appliance is used for other
purposes or in a wrong manner, the man ufacturer declines all responsibilities for possib le damages.
• For safety reasons, no modifications must be carried out on the appliance.
• Before connecting the appliance to the electr ic power supply system, chec k that the power supply at
the place of installation is compatible with the electric data indicated on the data tag.
• The installation must be carried out by qualified personnel.
Before running the appliance for the first time
• Make sure the dishwasher w as not damaged during transport. Do not hook up the appliance if there
is any damage. In case of damage, contact the vendor.
For the safety of children
• Do not allow children to play with the appliance.
• Detergents can cause permanent damage to eyes, mouth and throat.
They should therefore be kept outside the reach of children.
• The water in the dishwasher is not drinkab le. Any residues of detergent in the appliance constitute a
source of danger for children. They must therefore be kept away from the open dishwasher.
Daily use
• Do not turn on the dishwasher if the electric cable, or the water supply or water drainage pipes are
damaged, or if the control board, the work surface or the base are in very bad condition.
• In case of a malfunction, shut off the water supply, then turn off the appliance and pull the electric
plug from the outlet. If there is a permanent electric connection, turn off the service switch (if present)
or remove the fuse (or fuses).
• To remove the plug from the electric outlet, hold the plug itself and pull; never pull the cable .
• All repairs of the dishwasher must be carried out b y specialised personnel. Inappropriate repairs can
create a sev ere danger for the user . F or repairs, you should theref ore contact our technical customer
assistance service or a specialised vendor.
• The replacement of the supply cable must be carried out only by the technical service staff.
• If the pipes and tubes are deteriorated, substitute them with new original parts before hooking up
the appliance.
• Do not use detergent substances that could lead to an explosion.
• Do not sit or lean on the open door. The appliance might otherwise tilt over.
• Before adding special dishw asher salt, detergent and r inse aid, mak e sure that the man uf acturer of
these substances recommends their use for household dishwashers.
• Always shut off the water supply when the dishwasher is not in use for longer periods of time, e.g.,
during your vacations.
1.1 SAFETY INSTRUCTIONS
1234567890
1
23456789
0
1
23456789
0
1
23456789
0
1
23456789
0
1
23456789
0
1234567890
GB
2
UNPACKING – DISPOSAL
2
Remove the e xternal plastic packaging material, the corner re-enforcements, and the styrof oam base . Open
the door and remove the styrofoam blocks from the inside baskets.
Collect and recycle the packaging materials. This will preserve primary materials and help reduce the amount
of waste.
Take the packaging materials to specialised recycling centres .
When the appliance eventually has to be disposed of, it should be made non-functional before eliminating it.
Attention! Some packaging materials (e.g., plastic bags, styrofoam) can be
dangerous for children. Children should therefore be kept away from them.
When the appliance ev entually requires disposal, it should be made non-functional and a specialized
recycling company contacted for removal and disposal in accordance with current regulations.
This will make it possible to dispose of the old appliance while at the same time recuperating and
sorting synthetic materials that are fit for recycling, thus contributing to the protection of the en vironment.
2.2 FINAL DISPOSAL OF APPLIANCE
2.1 UNPACKING
3.1 WASHING DISHES IN AN ECONOMIC AND ECOLOGICAL WAY
GENERAL ADVICE
3
• Don’t rinse your dishes under running water before placing them in the dishwasher
• Run the appliance only when it is full, because only like this the process becomes economical and
respects the environment.
• Always choose a programme that is adequate for the kind of dishes you want to wash and that
corresponds to how dirty they are
• You should avoid to use too much detergent, dishwasher salt, and rinse aid. Refer to the dosages
recommended in the usage instructions provided by the manufacturers of these substances.
• Make sure that the water softness regulator is set correctly.
3.2 DISHES NOT TO BE WASHED IN THE DISHWASHER
You must not wash in this appliance:
- Cutting boards or small containers in wood
- Plastic objects that are not heat resistant
- Lead crystal
- Objects made from tin or copper
- Dishes or cutlery with glued components
- Old cutlery with heat sensitive glue
- Steel objects that are oxidised easily
- Cutlery with handles in wood, horn, antler, porcelain, or mother of pearl.
- Silverware
When purchasing dishes, cutlery, or glasses, make sure that they are
dishwasher resistant.
3
GB
0,05 - 1MPa Model. ......................
....A
MAX .......W
........V.....Hz
Made in EU
...................
12
DESCRIPTION OF THE APPLIANCE
4
1) salt container
2) rinse aid container
3) fan forced drying (for BDW10)*
4) container for detergent
5) data tag
6) filters
7) lower spray-arm
8) upper spray-arm
9) electric connection lead
10) water supply hose
11) water drainage hose
12) lower basket
13) upper basket
14) cutlery container
15) hook for door closing mechanism
4.1 GENERAL PARTS
4.2 TECHNICAL DATA
capacity (standard settings): 12
pressure of water supply system
minimum pressure: 0.05 Mpa
maximum pressure: 1 Mpa
Attention: the necessary characteristics
of the electric supply grid are indicated
on the data tag.
LA2505-020/1
1
1
9
10
11
14
5
8
13
15
6
12
3 2
7
4
*The final cycle of the dishwasher g enerates steam, which by definition is “air containing
water particles”. The energy-efficiency fan extracts the steam from the dishwasher. This
process accelerates and improves the final drying results.
1234567890
1
23456789
0
1
23456789
0
1
23456789
0
1
23456789
0
1
23456789
0
1234567890
GB
4
2
LA2505-030
P
5.1 LEVELLING
Place the appliance in the spot where you w ant to install it. Use feet P (unscrew or screw in) to regulate
(if necessary) the height of each foot to assure that the appliance is in a fully level position.
If the appliance is positioned in a level position, its correct functioning is assured.
Maximum error = 2 degrees
After lev elling the appliance, regulate the hook of the door closing mechanism, to assure that the door
closes perfectly.
In order to obtain a perfect seal adjust the door loc king de vice but only after having le velled the machine
in its final installation position.
INSTALLATION
5
5.2 WATER CONNECTION
The water supply tube C, which accompanies the
dishwasher, attaches to a 3/4” water tap.
During the installation, the following instructions must be
followed:
• Attach tube C to the cold water supply A.
• If the tube is being attached to new pipes that have not
been used for a long time, you should let the water run
for some time bef ore attaching the hose in order to mak e
sure that dirt and rust residues are eliminated.
• Make sure that the water pressure corresponds to the
range indicated on the data tag.
The appliance may be connected to the cold water system. It must not be connected to the hot w ater system.
2.1
M
3
LA2505-040
A
C
5.2 a LEAK PROTECTION/AQUA STOP (FOR BDW10)
As part of the security system your dishwasher has been installed with a leak detector (housed in
the base of the appliance). In the unlikely event of water leaking into the base of the diswasher, the
detector would activate and in turn initiating the aqua stop (which is part of the fill water hose) and
would shut off the incoming water supply.
5
GB
min 32 cm
max 80 cm
4
LA2501-050
T
T
5.3 CONNECTION OF DRAINAGE WATER
The curved end of drainage hose T, should be hooked into the drainage stand pipe or alternatively
over the edge of your sink.
During installation, the following precautions should be taken:
- the drainage hose must not be bent to or crushed;
- the hose end, relative to the top surface of the dishwasher (fig. 4), must be placed at a height
between 32 and 80 cm;
- the end of the hose must never be immersed in water;
- the drainage hose must not be e xtended to more than a maximum length of 1 metre . The e xtension
must have the same internal diameter. Fur ther more, the maximum height at which the hose end
can be placed (in the case of an extended tube) must be reduced from 80 to 50 cm.
- The drainage stand pipe must have an internal dia. of no less than 4 cm.
5.4 ELECTRIC CONNECTIONS
THIS APPLIANCE MUST BE EARTHED.
Electrical connection must be made via a correctly installed soc ket outlet. in accordance
to the current regulations in force at the time of installation.
If in any doubt, we recommend that you seek advise from a qualified electrician.
See data tag for appliance electrical requirements.
Loading...