ELECTRIC BUILT-IN OVENS
B260SS
B270M
B275M
.
USER AND INSTALLATION
1
LIB30112
For future reference please record the following information which can be found
on the Rating Plate and the date of purchase which can be found in the invoice:
Model Number ……………………………….
Serial Number ……………………………….
Date of Purchase ……………………………….
Supplier ……………………………….
INSTRUCTIONS
1. TECHNICAL DATA
MODELS
Rating voltage 230-240V 230-240V 230-240V
Fun heating element (2300W) ● ● ●
Lower heating element (1000W) ● ● ●
Traditional upper heating element (900W) ● ● ●
Traditional grill heating element (1900W) ● ● ●
Current 16 A 16 A 16 A
Maximum power 2800 W 2800 W 2800 W
Dimensions 596 x 596 x600 596 x 596 x600 596 x 596 x600
B260SS B270M B275M
B260SS
B270M-B275M
2. PRELIMINARY REMARKS
Please read this booklet thoroughly before you install and use this appliance. It is important that you
understand all the control functions before commencing to cook with this oven.
Warnings
• This oven is intended to be used only for baking purposes, therefore improper uses are not admitted.
• This oven must be used only by adult persons in good physical conditions. Please ensure that
• Always use the oven door handle for opening the door of the oven.
• Avoid contact with inner surfaces and the door of the oven , as they can reach high temperatures
• Cleaning operations must be carried out only when the temperatures are cold.
• In the event of any malfunctions with the oven and if no explanations are found in the fault analysis
• The appliance must be disconnected from the mains before executing cleaning operations.
• Repairs may only be carried out by Baumatic service engineers or their authorized agent.
• Packaging materials used are environmentally friendly and can be recycled. Please discard all
2
children are kept under close supervision at all times.
during baking and remain hot also after appliance has been turned off.
section of this manual, please turn off the appliance and call the customer services department.
packaging material with due regard for the environment.
• Cleaning of the oven should be carried out on a regular basis.
• Keep this instruction manual safe for persons not familiar with the operation.
3. DECLARATION OF CONFORMITY
In the parts destined to come into contact with foodstuffs, this appliance is in accordance with the requirements of
the EC directive 89/109 transposed in the Italian Legislative Decree N° 108 of 25/01/92.
CE Appliance conforming to the European directives 89/336/EEC, 93/68/EEC, 73/23/EEC and subsequent
revisions.
The manufacturer declares that the oven is built using certified materials and requires the appliance to be
installed in accordance with the standards currently in force. This appliance must be used by trained person
for domestic purposes only.
This appliance is marked according to the European directive 20002/96/EC on waste Electrical
and electronic Equipment (WEEE). This guideline is the frame of a europeanwide validity of
return and recycling on Waste electrical and electronic Equipment
4. INSTALLATION
The installation must be carried out by qualified personnel according to:
• Safety standards in force.
• Local electricity supply company advises.
Electric connections
• Check the details given on the rating plate situated on the oven making sure that the rated mains
voltage and power available are suitable for its operation. The data plate is placed on the bottom of
the control panel.
• Before making the electric connections, check the efficiency of the earthing system. Earthing of the
oven is compulsory by law. The manufacturer will accept no liability for any personal injury or
damage to property deriving from failure to comply with this requirement.
•
For models without a plug, fit a standard plug capable of withstanding the specified load on the power
cord. The cord’s earthing conductor is colored yellow and green. The plug must be accessible.
• This appliance should be wired into a suitably rated double pole switch with 3mm contact gap and placed
in an easily accessible position adjacent to the appliance.
• To connect the oven power cord, loosen and remove the cover on the terminal block in order to
access the contacts inside. Make the connection, blocking the cord in place with the cable clamp
provided and then close the terminal block cover again immediately.
• If you have to change the cord, the earthing (yellow / green) conductor must always be 10 mm
longer than the line conductors.
•
If damaged, the cable must be replaced with one supplied by the technical assistance service.
3
Fixing the oven to the unit
• Place the oven into the piece of kitchen furniture it is to be installed in.
• The holes of the holding screws are: top right and top left the frontal frame of the oven.
• Secure the oven with the fixing screws.
4
Loading...