BAUKNECHT KRIE 2125 A++ Daily Reference Guide

Quick guide

THANK YOU FOR BUYING A BAUKNECHT PRODUCT

In order to receive a more complete assistance, please register your product on www . bauknecht . eu / register

PRODUCT DESCRIPTION

FIRST TIME USE

Wait at least two hours, after the installation, before connecting the appliance to the power supply. Connect the appliance to the power supply it starts the operation automatically. The ideal storage temperatures for the food are preset in the factory.

CONTROL PANEL

ON/STANDBY

Press the button for 3 seconds to turn the appliance o. In Stand-by mode the light in the refrigerator compartment does not turn on. Press the button again briey to reactivate the appliance.

Note: this does not disconnect the appliance from the power supply.

FAN*

The Fan improves temperature distribution inside the product, allowing better preservation of stored food and reduction of excess humidity. You can turn the fan on/o by pressing the button on the base (as shown in the gure). If the ambient temperature exceeds 27°C, or if drops of water are present on the glass shelves, it is essential that the fan is on to ensure the proper preservation of the food. Deactivation of the fan allows energy consumption to be optimised.

Before using the appliance carefully read the Safety Instruction.

After turning the appliance on, you must wait for 4-6 hours for the correct storage temperature to be reached for a normally lled appliance. Position the antibacterial anti-odour lter in the fan as demonstrated in the lter packaging (if available). If the audible signal sounds, it means that the temperature alarm has intervened: press the button to switch o the acoustic alarms.

1. LED Light

2. On/Stand-by

3. Freezer and refrigerator compartment

temperature button

FREEZER AND REFRIGERATOR COMPARTMENT TEMPERATURE

The three LED indicators indicate the refrigerator compartment set temperature. It is possible to set a dierent temperature of the appliance with the

The following adjustments are possible:

LEDs lit Set temperature

button.

High (less cold)

Medium-high

Medium

Medium-low

Low (colder)

Fast cool

HOW TO STORE FOOD AND BEVERAGE

** For models with "0 ° ZONE" COMPARTMENT the "coolest area" is the one highlighted in the legend

* Available only on certain models

Legend

TEMPERATE ZONE

Suggested for storage of tropical fruit, cans, drink, eggs, sauces, pickles, butter, jam

COOL ZONE

Suggested for storage of cheese, milk, daily food, delicatessen, yoghurt

COOLEST AREA

Suggested for storage of cold cuts, desserts, meat and sh

FRUIT & VEGETABLE DRAWER

TROUBLESHOOTING

What to do if... Possible reasons Solutions

The control panel is switched o, the appliance does not work.

The inside light does not work.

The inside light ashes. Door alarm active.

The temperature inside the compartments is not low enough.

There is water on the bottom of the refrigerator compartment.

Excessive amount of frost in the freezer compartment.

The front edge of the appliance that the door gaskets seal against is hot.

One or more green symbols are ashing continuously and it is not possible to change the temperature set.

The temperature of the refrigerator compartment is too cold.

There may be an appliance power supply problem.

The appliance could be in On/stand by mode.

The light may need to be replace. Malfunction of a technical component.

It is activated when the refrigerator compartment door remains open for a prolonged period of time.

There could be various causes (see “Solutions”).

The defrost water drain is blocked. Clean the defrosting water drain (see section “Cleaning and

The door to the freezer compartment is not closed properly.

This is not a defect. It prevents condensation from forming.

Malfunction alarm. The alarm indicates a fault in a technical component.

• The set temperature is too cold.

• A large amount of fresh food may have been placed in the freezer compartment.

Check that:

• there is not a power outage;

• the plug is properly inserted in the socket and any bipolar power switch is in the correct position (this enables the power supply to the appliance);

• the household electrical system protection devices are ecient;

• the power cable is not damaged.

Turn the appliance on by briey pressing the by func tion).

Disconnect the appliance from the power supply and contact the Technical Assistance Service if you need a replacement.

To stop the alarm, close the refrigerator door. On reopening the door, check the light works.

Check that:

• the door closes properly;

• the appliance is not installed near a heat source;

• the set temperature is adequate;

• the circulation of air through the vents at the bottom of the appliance is not obstructed (see installation section).

Maintenance").

Check that there is nothing preventing the door from closing properly.

• Defrost the freezer compartment.

• Make sure the appliance has been correctly installed.

No solution is necessary.

Contact Technical Assistance Service.

• Try to set a less cold temperature.

• If fresh food has been placed in the freezer compartment, wait until it has fully frozen.

• Turn o the fan (if present) following the procedure described in the paragraph “FAN”.

button (see On/Stand-

* Available only on certain models

You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:

• Visiting our website docs . bauknecht . eu

• Using QR Code

• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When contacting our After-sales Service, please state the codes provided on your product's identication plate.

400011423818