Bauknecht GSI 5556 CTW-IN Quick Reference Guide
GB
GSI 5556
Rinse aid level indicator
Add rinse aid.
Salt level indicator
Add regeneration salt; only add regeneration salt
immediately before starting a wash programme.
Half Load button
This function can be used with any programme.
The indicator lamp switches on: the wash cycle is
activated for the upper
lower rack
or
Quick Reference Guide
Further indications are given in the pages to follow and in the user instructions.
Programme progress indicator
only
Pre-rinse /Pre-wash
Washing
Options
Delayed start button
The wash cycle can be programmed to start after
.
3-6-9 hours. Then press the Start button.
The dishwasher will start at the set time.
Drying
Programme end
Start button
Indicator lamp lit while the dishwasher
is operating.
Flashes when a fault occurs.
Switches off at the end of the programme.
Programme selector
Programme Symbol
and Temperature
Pre-wash
Rapid 40° C
Bio-Normal 50 °C
Normal 65° C
3)
Intensive 70° C
1) Values may vary in relation to usage, e.g.: different loads, water
temperatures - above or below 15° C - as well as water hardness and power supply voltage, etc.
2) Programme recommended when using detergents of type B (enzyme-based detergents).
Reference programme for energy label.
3) Programme recommended when using detergents of type A (non enzyme-based detergents).
Crockery to be washed later.
Lightly soiled crockery with no dried-on food.
2)
Normally or heavily soiled crockery with dried-on food.
Normally or heavily soiled crockery.
Heavily soiled pans and saucepans.
Programme selection and
recommended load type
Place the detergent in the:
small large
compartment compartment
Consumption
Normal load / (Half load)
Water
(Litres)
Energy
(kWh)
1)
- - 5.0 (4.2) 0.02 (0.02) 9(9)
- X 13.0 (13.0) 0.85 (0.75) 30 (30)
X X 16.0 (14.5) 1.03 (0.90) 120 (117)
X X 16.0 (14.2) 1.55 (1.40) 86 (83)
X X 21.5 (18.2) 1.70 (1.60) 93 (90)
5019 100 90348
(We reserve the right to make technical modifications)
Time
(Min.)
B
A
C
B
A
How to use the dishwasher
1. After loading the dishwasher, close the
door properly and open the water
supply tap.
2. The dishwasher switches on
automatically as soon as the
programme selector knob is turned.
One of the programme indicator
lamps will switch on.
3. Turn the selector knob to select the
desired programme.
indicator lamp lights up.
select options (if supplied).
4. Press the Start button to start the
selected programme.
indicator lamp will light up.
the programmed data cannot be
altered by turning the programme
selector knob.
once the Start button has been
Note:
pressed, the dishwasher memorises
the last programme selected. This
information remains in the memory even
during interruption of the power supply.
To change the programme selected,
press the Start button for about 5
seconds,
lamp switches off.
programme and press the Start
button.
If the dishwasher is switched off
Note:
during a wash programme, when
switched on again it will resume the wash
cycle from where it was interrupted.
Only open the dishwasher door if
strictly necessary during a wash cycle
and exercise maximum caution.
Danger of scalding from steam.
5. To indicate the end of the programme,
the Start indicator lamp switches off
and
the End indicator lamp (if fitted)
lights up
(for about 30 min.).
The corresponding
If necessary
The Start
Once set,
until the Start indicator
Select a new
6. Once the Start indicator lamp has
switched off, turn the programme
selector knob counter clockwise to the
initial position to switch off the
dishwasher.
switch off.
7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.
All the indicator lamps
Upper rack
Half Load:
If the upper rack
remove the cutlery basket from the lower
rack and place it in the upper one.
is to be loaded,
only
Rack height adjustment:
(The dishwasher is delivered with the
upper rack in the top position).
The rack height can also be chan ged
when loaded.
• To lower: pull out the
handles and gently lower the rack.
• To raise: pull up the
until the rack clicks into place.
side
two
side handles
two
Upper and lower rack
• The rack must be level on both sides.
Crockery holders:
• Down: cups and long-stemmed
glasses.
•
Up: plates.
“Vario Organizer” multi-purpose
support:
• To be used, for example, for longhandled utensils (
with the blade facing downwards),
cups and glasses.
• May be used in three different
positions (see also “Dishwasher
loading instructions” on Page 4).
1. Upon the left-hand side of the rack.
2. Upside-down, towards the centre of
the rack.
3. Upside-down, towards the left side.
Glass holder:
arrange knives
Lower rack
Half Load:
Loading the lower rack
greater washing power, especially
for plates and saucepans.
only
gives
Plate holders:
• May be lowered to increase
available space (A).
• May be removed to increase
available space (B). To remove:
Pull the handle up.
Cutlery basket:
The cutlery basket can be removed
to increase (C) available space.
C
Please read the user instructions carefully.
Loading...