Bauknecht TRAK 6330, GSI 4643 BW-IN, GSI 4643 BW-BR Quick Reference Guide

GB

GSI 4643

PROGRAMME CHART

Start button indicator lamp

Switches “on” when the dishwasher is operating.
Flashes when a fault occurs.
Switches “off” at the end of the programme

Programme
Symbol and

Temperature

Pre-rinse

Rapid 40° C

Bio-Normal 50° C

Normal 65° C

*) Values for normal conditions. Values may vary in relation to usage, e.g.: different loads, water temperatures, water hardness and power supply voltage

1) Programme recommended when using detergents of type A (non enzyme-based detergents).

2) Programme recommended when usingdet ergent soft ypeB(enzyme-based detergents).
Check the programme on the energy data plate.

Crockery to be washed later.

Lightly soiled crockery with no dried-on food.

2)

Normally or heavily soiled crockery with dried-on food.

1)

Normally or heavily soiled crockery.

Crockery and cutlery

Load

Detergent

Pre-rinse

(small

compartment)

--5.00.029---

- + 13.0 0.85 85 - - -

+ + 18.0 1.40 87 - - -

+ + 18.0 1.60 87 - - -

Pre-rinse

(large

compartment)

(We reserve the right to make technical modifications)

Consumption *

Normal load

Water

(Liter)

Energy

(kWh)

Time

(Min.)

5019 100 90504

Quick Reference Guide

GB

Daily check list

1. Arrange crockery so that items do
not touch each other.

2. Load cups at an inclination to
facilitate water circulation.

3. In general, place cutlery in the ba sket
with the handles positioned
downwards, but ensure that any
sharp knives and forks that might
cause injury are placed in the basket
with the handles positioned upwards.

4. Make sure the water jet can reach
all loaded items and that the spray
arms turn freely.

5. Turn on the water supply tap before
starting the dishwasher.

Important:

• Switch off the dishwasher: once
the “Start” indicator lamp has
switched off.
If you switch off the dishwasher
during a wash cycle, when
switched on again the
dishwasher resumes the cycle
from where it was interrupted.

• If a fault occurs or you wish to
change the current programme,
press the “START” button for
about 5 seconds until the Start
indicator lamp switches off! Refer
to the “Troubleshooting Guide”
in these user instructions to
remedy any problems.

• If a regeneration salt is to
be added, IMMEDIATELY
start a washing programme,
in order to eliminate any
residual salt.

• If a fault occurs or you wish to
change the current programme,
press the “START” button.
Sometimes even when the
regeneration salt container is full,
the corresponding indicator
lamp may illuminate during the
first wash cycle.

Crockery Holders:

• Down: cups and long-stemmed
glasses.

• Up: plates.

Upper rack

Lower rack

Cutlery Basket:

The cutlery basket can be removed to
increase available space.

Also refer to the “Dishwasher Loading Instructions” which contain detailed information and useful tips.