Bauknecht GSI 4634 RW-IN, GSI 4634 RW-BR, GSI 4634 RW-WS, GSI 4634 RW-SW Quick Reference Guide

GSI 4634

Quick Reference Guide

Further indications are given in the pages to follow and in the user instructions.

Programme selector

Start button

Indicator lamp lit while the dishwasher is oper ating. Flashes when a fault occurs. Switches off at the end of the programme.

Programme Symbol

and Temperature

Pre-wash

Bio-Normal 50° C

Normal 65° C

1) Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15° C - as well as water hardness and power supply voltage.

2) Programme recommended when using detergents of type B (enzyme-based detergents). Reference programme for energy label.

3) Programme recommended when using detergents of type A (non enzyme-based detergents).

Crockery to be washed later.

Normally or heavily soiled crockery with dried-on food.

Programme selection and

recommended load type

Place the detergent in the:

small large

compartment compartment

(Litres)

- - 5.0 0.02 9

X X 16.0 1.35 86

X X 16.0 1.55 86

Water

Consumption

Normal load

Energy

(kWh)

5019 100 90300

(We reserve the right to make technical modifications)

Time

(Min.)

How to use the dishwasher

1. After loading the dishwasher, close t he door properly and open the water supply tap.

2. The dishwasher switches on automatically as soon as the programme selector knob is turned.

One of the programme indicator lamps will switch on.

3. Turn the selector knob to select the desired programme.

corresponding indicator lamp lights

If required, select options

up.

(if supplied).

4. Press the Start button to start the selected programme.

indicator lamp will light up.

the programmed data cannot be alte red by turning the programme selector knob.

once the Start button has been

Note:

pressed, the dishwasher memorises the last programme selected. This information remains in the memory even during interruption of the power supply.

To change the selected programme, press the Start button for about 5 seconds

indicator lamp switches off.

Select a new programme using the programme selector knob and press the Start button.

if the dishwasher is switched off

Note:

during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted.

Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. Danger of scalding from steam.

5. To indicate the end of the programme, the Start indicator lamp switches off and

the End indicator lamp (if fitted)

lights up

(for about 30 min.)

The

The Start

Once set,

, until the Start

6. Turn the programme selector knob counter clockwise to the “0” position to switch off the dishwasher (only after the Start indicator lamp has switched off).

All the indicator lamps switch off.

7. Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. Close the water tap.

Upper rack

Rack height adjustment:

(The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded.

• To lower: pull out the handles and gently lower the rack.

two

side

Upper and lower rack

• To raise: pull up the until the rack clicks into place.

• The rack must be level on both sides.

Crockery holders:

• Down: cups and long-stemmed glasses.

•

Up: plates.

side handles

two

Lower rack

Cutlery basket (C):

• With or without handle (depending on model).

• The cutlery basket can be remo ved to increase available space.

Please read the user instructions carefully.

+ 2 hidden pages